Digi installation manual 2 DC-190 Keypad

1.4.2DC-190 Keypad

Table 1-5 lists the keys and key functions of the DC-190 Ultra Count keypad (see Figure 1-1 on page 4).

				Key		Description
				through		Used to enter numeric values. When using the scale, first enter a numeric value, then press the
	0				9	appropriate function key.
						Used to enter numeric values containing a decimal point. NOTE: A numeric value must be entered
						before the decimal point. For example, .250 would be entered as 0.250. In normal mode, pressing
						the decimal key without entering a numeric value allows you to recall an item code from memory
						using the Teraoka Code (see Section 10.8 on page 58).
						Clears keyed-in data from the display starting with the last digit entered or clears keyed-in data all
	CLEAR					at once (depends on SPEC 6, bit 2 setting). In normal weighing mode, can be used to clear the
						unit weight with a unit weight already entered. When using a recalled item code, press CLEAR to
						clear both the unit weight and the tare weight.
						Switches display between pound (lb) and kilogram (kg). The scale powers up in the pound mode.
	kg
			lb
						Used to cycle through Scales 1 through 4.
	SCALE
						Used to compute unit weight by sampling. Press the PIECES key after placing a 10-piece sample
						on the platform, or after using the numeric keypad to enter the sample size. On multichannel units,
	PIECES
						the scale used must be selected.
						Used to set and clear tare weights in the normal weighing mode.
			TARE
						Used to reset the scale to zero. Also used in conjunction with other keys to enter the maintenance
						mode. The REZERO key will not function when the scale is in motion.
	REZERO
						Used to enter a known unit weight using the numeric keypad.
			UNIT
	WEIGHT
						Switches between net weight and gross weight display modes. Also used as an inventory key
			NET/
	GROSS					(depends on SPEC 2, bit 0 setting).
	INVENT
						Used to enter the program mode. The MODE annunciator is illuminated when the scale is in
	MODE					program mode and the WEIGHT display reads ProG. The quantity display shows the letter C and
						the number of item codes in memory.
						Powers the scale on or off.
	ON
			OFF
			-			Used to operate the reduction function and to move between specification numbers (high to low)
						in SPEC setting mode. Also used to program part number in programming item codes. In
			DATE			programming mode, it can be used for viewing or setting date/time.
+						Used to operate the accumulation function and to move between specification numbers (low to
						high) in SPEC setting mode. Also used to program set points in programming item codes.
*						Used to store specification data in SPEC setting and program modes. Also used as a print key to
						transmit weight information.
		PROG
						Used to recall item code data and to switch between item code inventory IN and OUT modes.
	CODE					Also used to program commodity name in programming item codes.
	IN / OUT
						Table 1-5. DC-190 Keypad Keys and Functional Descriptions