illuminated and the display shows the quantity of parts remaining.
6.Remove a number of parts from the container and press the – key again. The MEMORY annunciator is illuminated and the display shows the quantity of parts remaining.
NOTE: If SPEC 32, bit 1 (Auto Exit from Part Accumulation and Reduction Mode) is set to 0, the scale will not auto exit from displaying the total amount. To return to the weighing mode, press the CLEAR key.
6.5.3Clearing Accumulated Data
To clear accumulated data, press the * key.
6.6Other Operations
The following operations, added in software Version 4.02 and 4.04, can all be performed while the
6.6.1Set New Vendor Name
In software Version 4.02 or later, a new vendor (company) name can be scanned into the
1.Scan the VENDOR NAME barcode using the bar code board (see Section 10.9 on page 59).
2.Use the alphanumeric bar codes to scan up to 48 characters for the vendor name.
3.When complete, scan the ENTER bar code.
SPEC 44, bit 2, (input company name with bar board) must be set to 1 to use this function (see page 24).
6.6.2Set New Operator Name
In software Version 4.02 or later, a new operator name can be scanned into the
1.Scan the OPERATOR NAME barcode using the bar code board (see Section 10.9 on page 59).
2.Use the alphanumeric bar codes to scan up to 32 characters for the operator name.
3.When complete, scan the ENTER bar code.
SPEC 44, bit 3, specifies whether the operator name is held in memory or is cleared after each use (see page 24).
6.6.3Set New Batch Print Quantity
In software Version 4.04 or later, the number of labels printed for a batch can be changed by doing the following:
1.Press and hold the REZERO key and enter 111 using the numeric keypad.
2.The display shows the batch print quantity. Use the numeric keypad to enter the number of labels to print.
3.Press the * key to store the batch print quantity, then press MODE to exit programming mode and return to weighing mode.
Batch print quantity can also be set using a scanner and the BATCH PRINT barcode (see Section 10.9 on page 59).
6.6.4Set New Sequence Number
In software Version 4.04 or later, the sequence number can be reset by doing the following:
1.Press and hold the REZERO key and enter 112 using the numeric keypad.
2.The display shows the sequence number. Use the numeric keypad to enter the new sequence number.
3.Press the * key to store the sequence number, then press MODE to exit programming mode and return to weighing mode.