A&D 1WMPD4002313 manual Unpacking

Page 6

3. UNPACKING

Unpack the indicator carefully and keep the packing material if you are likely to transport the indicator again in the future.

When unpacking, check whether all of the following items are included:

Indicator	Model label
Indicator	(1083014607)
	To be attached.

Connector plug

(1JMNJW-165-PM7)

Display stand

Hexagonal wrench

(1.27 mm / 0.05 inch)

Main power cord

Please confirm that the main power type is correct for your local voltage and receptacle.

Set Up Instruction			Instruction manual
(this manual)			FS-iseries

	FS-D			FS-iseries

SET UP INSTRUCTION

INSTRUCTION MANUAL

4

Image 6

Contents Weighing Indicator This Manual and Marks Contents Compliance Compliance with FCC rulesClassification of protection provided by enclosures Introduction Unpacking Precautions for Installing the Indicator Load Cell ConnectionsVerifying Load Cell Output and Input Sensitivity Calculating formulaExample of calculation Setting Up the Indicator Parameter Settings and CalibrationNames and Functions Names Functions / Operation Comparison Indicators Function Parameter Settings Procedure for setting parameters00Cal00 C01-01 -C02-01 -C02-00-C02-02-C03-01-00end00 Function list 00 Cal00 Calibration using a weightCalibration 00Cal00Go to of 7-1. Calibration using a weight 00end00Gravity acceleration correction AUTO-TARE Function Circuit diagram Additional InformationOP-03 RS-232C Data output mode f06 2-3. Command ModeData format Multi-connection with Print key mode new function OP-04 RS-422Error Messages Lb1Err-# Specifications SpecificationsCapacity and minimum display Dimensions OptionsPage Korea Limited UK OfficeGerman Sales Office Instruments India Private Limited