Braun Series7 manual Before shaving, Installing the Clean&Renew station

zShaver power socket u Travel case

i Special cord set

Before shaving

Prior to first use you must connect the shaver to an electrical outlet using the special cord set i or alternatively proceed as below.

Installing the Clean&Renew station

•Using the special cord set i, connect the station power socket 6 to an electrical outlet.

•Press the lift button 2 to open the housing.

•Hold the cleaning cartridge 7 down on a flat, stable surface (e.g. table).

•Carefully remove the lid from the cartridge.

•Slide the cartridge into the base of the station as far as it will go.

•Slowly close the housing by pushing it down until it locks.

The cleaning fluid display 1 will show how much fluid is in the cartridge:

«high»	up to 30 cleaning cycles available
«low»	up to 7 cleaning cycles remaining
«empty»	new cartridge required

Charging and cleaning the shaver

Insert the shaver head down into the cleaning station. (The contacts t on the back of the shaver will align with the contacts 3 in the cleaning station).

If required, the Clean&Renew station will now charge the shaver. The hygiene status of the shaver will also be analyzed and one of the following cleaning program diodes 5 will light up:

«clean»	shaver is clean
«eco»	short economical cleaning required
«normal»	normal level of cleaning required
«intensive»	high intensive cleaning required

If the station selects one of the required cleaning programs, it will not start unless you press the «start cleaning» button 4. For best shaving results, we recommend cleaning after each shave.

clean

eco

normal intensive

autoselect

	ng
		eco
		normal
	fa	intensive
	high	auto select
1	low
	empty
	2
	f	new

	high	high
low	low	low
empty	empty	empty

trim mer

ashable w

fast c

rt cleani
sta	ng	clean
		eco
		normal
fast clean		intensive
	auto select
	washable
	art cleaning	clean
	st
		normal
	n	intensive
	f ast clea
	high
		auto select
	low

13