Braun 32899 Rev A manual Power Ramp Operation, UhvxowLqGdpdjh

Power Ramp Operation

The power ramp is activated by the One-Touch electronic control system. When a control switch is pressed to start the Open func- tions, the power door opens. Once the door reaches the fully open po- sition, there is a slight delay before the ramp begins to deploy.

When the Close functions are activated, the ramp (stows) im- mediately.

If a control switch is pressed and released while the ramp is de- ploying, the ramp motor will stop running. Press a switch again and the ramp will stow and the door will close.

Once the Open sequence of func- tions is complete (door is fully open

and ramp is deployed), press and release a control switch to stow the ramp. If a control switch is pressed while the ramp is stowing, the ramp will reverse direction (deploy fully and stop). Press a control switch again and the ramp will stow and the door will close.

Note: If the center console Kneel On/Off switch is in the ON position, the rear of the vehicle will descend as the ramp is deploying. Inversely, the vehicle will raise when the ramp is stowing.

Manual operation of the passen- ger slide door handles will disable ramp deployment. To enable ramp deployment, close the passenger slide door using the keyless entry transmitter, any interior mounted switch or the magnetic entry (if equipped).

OPERATION

If the power ramp is obstructed while deploying, the ramp will reverse direction and stow fully SURYLGHGWKHUDPSPHHWVVXIÀ- cient resistance).

Allow the power ramp to deploy (unfold and lower) fully before boarding the ramp. Forcing the ramp out or down during the deploy/stow functions, or board- ing onto the ramp before it is fully deployed PD\UHVXOWLQGDPDJH to the ramp, the electronic control- ler and/or motor assembly.

CAUTION

$OORZUDPSWRGHSOR\ IXOO\EHIRUHERDUGLQJ )DLOXUHWRGRVRPD\

UHVXOWLQGDPDJH

Page 19