Lifescan Diabetes Monitoring System manual Apply Control Solution

Page 26

Step 2: Apply Control Solution.

Shake the control

Step 3: Control Solution Result Appears in 45 Seconds.

Plussolution vial well before using. If there are any bubbles on

M the top of the vial,

wipe them off with a

clean tissue. Remove the cap and apply a

drop of control solution to the middle of the test spot, covering it completely. Do not dab, wipe, or

Compare the control solution test result with the ONE TOUCH™ Normal Control Range printed on the test strip vial. When you get a control solution test result within the control range, you are ready to test your blood.

M	C
(Example)

smear control solution on the test spot. Avoid contaminating the control solution. Do not touch the test spot with the tip of the vial.

Note: The control solution range is shown in two different units of measure—mg/dL and mmol/L.

ONE TOUCH™ Normal Control Range

(Example)

19

Image 26

Contents Owner’s Booklet Dear ONE Touch TM Basic TM Plus Owner Page Page Table of Contents Using the Meter Memory Solving Problems Precautions and Limitations Infection Control Getting Started Page ONE Touch Basic Plus Blood Glucose Meter ButtonPage ONE Touch Test Strips Important Test Strip Information Before Testing Setting Meter CodePress the On/Off Button Match the Code NumbersChecking the System Code the MeterChecking with the Check Strip Step When insert code 10 ExamplePress the On/Off Button. Insert Side 1 of the Check Strip Appears, Remove the Check Strip from the Test Strip HolderExample Checking with Control Solution Page Important Control Solution Test Information When insert code10 Press On/Off Button. Insert Test StripApply Control Solution Control Solution Result Appears in 45 SecondsControl solution results Detailed Test Procedure Penlet Plus Adjustable Blood SamplerGetting a Drop of Blood Page Cock the Penlet Plus Sampler Wash Your HandsLance Your Finger Remove the LancetAlways use caution when removing Check code and then Remove a test strip Apply Blood Sample Accurate Results in 45 Seconds Special Messages Checking the Amount of Blood on the Test Strip Page Using the Meter Memory Entering the Memory Mode Recalling Test Results Setting Meter Options Entering and Using the Set-Up ModePage Clock Time and Date Setting the Time Beep Prompts Language Time Format Date FormatUnit of Measure Decimal SeparatorExiting the Set-Up Mode Code Solving ProblemsTest Procedure Messages Check code Insert Code 1 0 Example Strip wait Apply sampleInsert s i d e Alternating with Error Messages Battry Clean test area Remove stripError 1 retest Error 2 retestMessage Problem What to do Error3 retest Not enough blood retestT o k D o a RetestMeter requires a Taking Care Your Meter Cleaning the Meter Doing a Daily CheckClean the Test Strip Holder Remove the Test Strip Holder from the MeterClean the Test Area Do not USEReplace the Test Strip Holder Replacing the Batteries To replace the batteries References Specifications Result Range 0-600 mg/dLWarranty Three-Year WarrantyPage Page IFD/OB/OTBP