Lifescan Diabetes Monitoring System manual

Page 40

Front Side

(Correct)

If the following message

appears on the display, your drop of blood was too small, or smeared, or the test strip was not pushed all the way into the test strip holder. Repeat the test with a new test strip and enough blood to cover the entire test spot.

■ Remove the test strip from the meter and look at the test spot. It should still have a wet, shiny drop that completely covers the test spot. If the blood sample

has a dull, dry appearance, you may not have applied enough blood, or you may have smeared it.

33

Image 40

Contents Owner’s Booklet Dear ONE Touch TM Basic TM Plus Owner Page Page Table of Contents Using the Meter Memory Solving Problems Precautions and Limitations Infection Control Getting Started Page ONE Touch Basic Plus Blood Glucose Meter ButtonPage ONE Touch Test Strips Important Test Strip Information Before Testing Setting Meter CodePress the On/Off Button Match the Code NumbersChecking the System Code the MeterChecking with the Check Strip When insert code 10 Example Press the On/Off Button. Insert Side 1 of the Check StripStep Appears, Remove the Check Strip from the Test Strip HolderExample Checking with Control Solution Page Important Control Solution Test Information When insert code10 Press On/Off Button. Insert Test StripApply Control Solution Control Solution Result Appears in 45 SecondsControl solution results Detailed Test Procedure Penlet Plus Adjustable Blood SamplerGetting a Drop of Blood Page Cock the Penlet Plus Sampler Wash Your HandsLance Your Finger Remove the LancetAlways use caution when removing Check code and then Remove a test strip Apply Blood Sample Accurate Results in 45 Seconds Special Messages Checking the Amount of Blood on the Test Strip Page Using the Meter Memory Entering the Memory Mode Recalling Test Results Setting Meter Options Entering and Using the Set-Up ModePage Clock Time and Date Setting the Time Beep Prompts Language Time Format Date FormatUnit of Measure Decimal SeparatorExiting the Set-Up Mode Test Procedure Messages Solving ProblemsCode Check code Insert Code 1 0 Example Strip wait Apply sampleInsert s i d e Alternating with Error Messages Battry Clean test area Remove stripError 1 retest Error 2 retestMessage Problem What to do Error3 retest Not enough blood retestT o k D o a RetestMeter requires a Taking Care Your Meter Cleaning the Meter Doing a Daily CheckClean the Test Strip Holder Remove the Test Strip Holder from the MeterClean the Test Area Do not USEReplace the Test Strip Holder Replacing the Batteries To replace the batteries References Specifications Result Range 0-600 mg/dLWarranty Three-Year WarrantyPage Page IFD/OB/OTBP