Lifescan Diabetes Monitoring System manual Checking with the Check Strip

Page 19

Checking with the Check Strip

A purple and white check strip is included in the carrying case of your ONE TOUCH™ BASIC™ Plus System. Before doing a check strip test, make sure the test strip holder, test area, and check strip are clean, dry, and lint-free. Do the check strip test at room temperature (between 18° and 26°C [64°–79°F]).

Front Back
1	2
✔	✔
	80403U
(Example)

Do a check strip test:

■At least once each day you test your blood

■After cleaning the meter

■Whenever your blood glucose test results are not consistent with how you feel, or when you think your results are not accurate

■If you drop the meter

■If you get the meter wet

■Whenever the following message appears:

12

Image 19

Contents Owner’s Booklet Dear ONE Touch TM Basic TM Plus Owner Page Page Table of Contents Using the Meter Memory Solving Problems Precautions and Limitations Infection Control Getting Started Page Button ONE Touch Basic Plus Blood Glucose MeterPage ONE Touch Test Strips Important Test Strip Information Setting Meter Code Before TestingMatch the Code Numbers Press the On/Off ButtonCode the Meter Checking the SystemChecking with the Check Strip Appears, Remove the Check Strip from the Test Strip Holder When insert code 10 ExamplePress the On/Off Button. Insert Side 1 of the Check Strip StepExample Checking with Control Solution Page Important Control Solution Test Information Press On/Off Button. Insert Test Strip When insert code10Control Solution Result Appears in 45 Seconds Apply Control SolutionControl solution results Penlet Plus Adjustable Blood Sampler Detailed Test ProcedureGetting a Drop of Blood Page Wash Your Hands Cock the Penlet Plus SamplerRemove the Lancet Lance Your FingerAlways use caution when removing Check code and then Remove a test strip Apply Blood Sample Accurate Results in 45 Seconds Special Messages Checking the Amount of Blood on the Test Strip Page Using the Meter Memory Entering the Memory Mode Recalling Test Results Entering and Using the Set-Up Mode Setting Meter OptionsPage Clock Time and Date Setting the Time Beep Prompts Language Date Format Time FormatDecimal Separator Unit of MeasureExiting the Set-Up Mode Test Procedure Messages Solving ProblemsCode Insert Code 1 0 Example Strip wait Apply sample Check codeInsert s i d e Alternating with Error Messages Battry Remove strip Clean test areaError 2 retest Error 1 retestMessage Problem What to do Not enough blood retest Error3 retestT o k Retest D o aMeter requires a Taking Care Your Meter Doing a Daily Check Cleaning the MeterRemove the Test Strip Holder from the Meter Clean the Test Strip HolderDo not USE Clean the Test AreaReplace the Test Strip Holder Replacing the Batteries To replace the batteries References Result Range 0-600 mg/dL SpecificationsThree-Year Warranty WarrantyPage Page IFD/OB/OTBP