Lifescan Diabetes Monitoring System manual Clean the Test Area, Do not USE

Page 69

Step 3: Clean the Test Area.

CAUTION: Do not get water inside the meter. Do not immerse meter in water.

The following cleaning agents will damage the meter.

DO NOT USE:

■Alcohol

■Cleansers with ammonia or phenol

■Glass cleaners

■Abrasive cleansers

M

C

Check the clear, protective coating over the test area to make sure it is not scratched or damaged.

Rub the test area with a cotton swab or soft cloth dampened with water to remove all blood, dirt, or lint from the test area. If necessary, a mild liquid dishwashing detergent mixed with water may also be used. Do not apply full-strength detergent to the test area. Be careful not to scratch the test area. Dry the test area with a soft, dry tissue or cloth. Remove any lint.

M

C

62

Image 69

Contents Owner’s Booklet Dear ONE Touch TM Basic TM Plus Owner Page Page Table of Contents Using the Meter Memory Solving Problems Precautions and Limitations Infection Control Getting Started Page Button ONE Touch Basic Plus Blood Glucose MeterPage ONE Touch Test Strips Important Test Strip Information Setting Meter Code Before TestingMatch the Code Numbers Press the On/Off ButtonCode the Meter Checking the SystemChecking with the Check Strip Press the On/Off Button. Insert Side 1 of the Check Strip When insert code 10 ExampleStep Appears, Remove the Check Strip from the Test Strip HolderExample Checking with Control Solution Page Important Control Solution Test Information Press On/Off Button. Insert Test Strip When insert code10Control Solution Result Appears in 45 Seconds Apply Control SolutionControl solution results Penlet Plus Adjustable Blood Sampler Detailed Test ProcedureGetting a Drop of Blood Page Wash Your Hands Cock the Penlet Plus SamplerRemove the Lancet Lance Your FingerAlways use caution when removing Check code and then Remove a test strip Apply Blood Sample Accurate Results in 45 Seconds Special Messages Checking the Amount of Blood on the Test Strip Page Using the Meter Memory Entering the Memory Mode Recalling Test Results Entering and Using the Set-Up Mode Setting Meter OptionsPage Clock Time and Date Setting the Time Beep Prompts Language Date Format Time FormatDecimal Separator Unit of MeasureExiting the Set-Up Mode Solving Problems Test Procedure MessagesCode Insert Code 1 0 Example Strip wait Apply sample Check codeInsert s i d e Alternating with Error Messages Battry Remove strip Clean test areaError 2 retest Error 1 retestMessage Problem What to do Not enough blood retest Error3 retestT o k Retest D o aMeter requires a Taking Care Your Meter Doing a Daily Check Cleaning the MeterRemove the Test Strip Holder from the Meter Clean the Test Strip HolderDo not USE Clean the Test AreaReplace the Test Strip Holder Replacing the Batteries To replace the batteries References Result Range 0-600 mg/dL SpecificationsThree-Year Warranty WarrantyPage Page IFD/OB/OTBP