Lifescan Diabetes Monitoring System Check code, Insert Code 1 0 Example Strip wait Apply sample

Page 54

MESSAGE

APPEARS WHEN

 

 

check code

The meter is turned on. This is a reminder that prior to testing you should verify that the code displayed on the meter matches the code on the test strip vial. If it does not, reset by pressing the C button.

insert

c o d e 1 0 (Example)

strip wait

apply sample

45 . . . . . 0

The meter is ready to perform a blood, check strip, or control solution test.

The meter is performing internal checks.

The meter is ready to receive a blood or control solution sample. If performing a check strip test, this is your signal to remove the check strip from the meter.

The meter is counting down from 45 seconds to 0.

47

Image 54
Contents Owner’s Booklet Dear ONE Touch TM Basic TM Plus Owner Page Page Table of Contents Using the Meter Memory Solving Problems Precautions and Limitations Infection Control Getting Started Page ONE Touch Basic Plus Blood Glucose Meter ButtonPage ONE Touch Test Strips Important Test Strip Information Before Testing Setting Meter CodePress the On/Off Button Match the Code NumbersChecking the System Code the MeterChecking with the Check Strip Step When insert code 10 ExamplePress the On/Off Button. Insert Side 1 of the Check Strip Appears, Remove the Check Strip from the Test Strip HolderExample Checking with Control Solution Page Important Control Solution Test Information When insert code10 Press On/Off Button. Insert Test StripApply Control Solution Control Solution Result Appears in 45 SecondsControl solution results Detailed Test Procedure Penlet Plus Adjustable Blood SamplerGetting a Drop of Blood Page Cock the Penlet Plus Sampler Wash Your HandsLance Your Finger Remove the LancetAlways use caution when removing Check code and then Remove a test strip Apply Blood Sample Accurate Results in 45 Seconds Special Messages Checking the Amount of Blood on the Test Strip Page Using the Meter Memory Entering the Memory Mode Recalling Test Results Setting Meter Options Entering and Using the Set-Up ModePage Clock Time and Date Setting the Time Beep Prompts Language Time Format Date FormatUnit of Measure Decimal SeparatorExiting the Set-Up Mode Solving Problems Test Procedure MessagesCode Check code Insert Code 1 0 Example Strip wait Apply sampleInsert s i d e Alternating with Error Messages Battry Clean test area Remove stripError 1 retest Error 2 retestMessage Problem What to do Error3 retest Not enough blood retestT o k D o a RetestMeter requires a Taking Care Your Meter Cleaning the Meter Doing a Daily CheckClean the Test Strip Holder Remove the Test Strip Holder from the MeterClean the Test Area Do not USEReplace the Test Strip Holder Replacing the Batteries To replace the batteries References Specifications Result Range 0-600 mg/dLWarranty Three-Year WarrantyPage Page IFD/OB/OTBP