ASSEMBLY OF HI/LO ACTUATOR/MOTOR TO DRAG LINK & U-LEVER
Detail a
Hi/Lo actuator motor to middle Drag Link Bracket
Detail B
Hi/Lo actuator motor assembly to Head end Drag Link mounting Bracket
use the middle hole on the
Item # | Qty. | Part # | Description |
|
|
|
|
1 | 1 | Main Frame Weldment | |
|
|
|
|
2 | 1 | Drag Link Weldment | |
|
|
|
|
3 | 1 | ||
|
|
|
|
4 | 1 | 12mm Dia. x 45mm Clevis Pin w/Hole | |
|
|
|
|
5 | 1 | ||
|
|
|
|
6 | 2 | .50” x 2.00” Clevis Pin w/Hole | |
|
|
|
|
7 | 1 | .50” Reg. .062 Rue Ring | |
|
|
|
|
8 | 1 | Hi/Lo Actuator/Motor Assembly | |
|
|
|
|
to repLace tHe matrIX II HI/Lo actUator/motor YoU mUSt orDer tHe entIre HI/Lo motor aSSemBLY
tHe HI/Lo motor IS not SoLD SeparateLY For tHe matrIX II BeD.
top HoLes Are not used
Detail c Important: You must use the second hole from the top on the drag link mounting bracket on all matrix II beds for proper operation.
Basic American Medical products, a division of GF Health products, Inc. • Matrix II • rev d Manual | p34 |