A ssembly - standard wallsaver (with optional trapeze positioning)
1.The Matrix II 709 standard wireform wallsaver is easily attached to the
2.From the inside, locate the bottom last hole in the carriage bracket on both sides of the bed. Holding the wallsaver in a 45° position as shown, squeeze its sides inward toward center and insert the ends of the wallsaver into the bracket holes. (See Detail A)
3.Carefully lower the wallsaver downward until it rests on the floor. The flat insert tab will turn within the bracket hole, locking the wallsaver into place. (See Detail B).
4.The position of the wallsaver is very important on the Matrix II bed. It has been designed so that the bed will be kept a safe distance from the wall when raising or lowering the bed, thus preventing damage to the bed or resident/facility walls.
NO SPECIAL Tools REQUIRED
FLAt tAB | FLAt tAB Locks Into |
Inserted | cArrIAGe BrAcket |
so tHAt It | BY turnInG It |
Is pArALLeL | perpendIcuLAr |
WItH sLot In | once It Is |
cArrIAGe BrAcket | InsIde HoLe |
FLAt Insert tAB
Item # | Quantity | Part # | Description |
|
|
|
|
1 | Reference | Standard Caster Carriage Assembly | |
(Also works on Locking Carriage Assembly | |||
|
|
|
|
2 | 1 |
| Standard Wireform Wallsaver - 76”, 80”, or 84” |
|
|
|
|
WALLsAver posItIon For trA- 
peZe
stAndArd WALLsAver posItIon
cArrIAGe BrAcket For 80” Bed
Basic American Medical products, a division of GF Health products, Inc. • Matrix II • rev d Manual | p13 |