Assembly - OPTIONAL foot board EMBEDDED STAFF CONTROL
Item # | Qty | Part # | Description |
|
|
|
|
| STAFF CONTrOL ASSEMBLy KIT (ZL788053) INCLuDES: | ||
|
|
|
|
1 | 1 | Z53650 | Std. Oak Head- & Footboard (with cut out) |
|
|
|
|
2 | 1 | Staff Control Assembly with Cables | |
|
|
|
|
3 | 1 | Wide Staff Control Shroud | |
|
|
|
|
4 | 6 | #6 x .50” Phillips Truss Head Screws (Blk) | |
|
|
|
|
5 | 3 | 4” Nylon Cable Tie | |
|
|
|
|
|
| Mounting Tube to Main Frame Hardware | |
|
|
|
|
6 | 2 | 5/16 x 1.50” Clevis Pin w/hole (existing) | |
|
|
|
|
7 | 2 | ||
|
|
|
|
1.Assemble the footboard mounting tubes to the “staff control footboard” as shown on the previous pages if not already assembled. Note that the standard footboard does not have the cut outs for the staff control assembly. A separate footboard with cut outs must be ordered for the staff controller option.
2.Facing the footboard from the
#6 X .50” Phillips Truss Head Screws (#4), from the back of the footboard secure the Staff Control via the outermost holes.
3.Place the Staff Control Shroud (#3) over the cables on the back of the footboard and attach with four black #6 X .50” Phillips Truss Head Screws (#4). Lightly tighten all screws with a phillips screwdriver. Tie the cables to the mounting tubes with ties (#5).
4.Insert the Footboard Mounting Tubes into the Main Bed Frame Tubes so that the holes match up as shown. Secure with two 5/16 x
5.Unplug the Pendant cable from the Extension Cable that’s already attached to the left side frame rail at the foot end of the bed.
6.Plug the male staff control cable into the cable extension that has been plugged into the control box in the HB Port. Plug the Pendant cable into the female staff control cable.
7.Tighten all screws on the Footboard with a phillips screwdriver. Be careful not to overtighten.
to safely remove Hair pin clip grasp on circular end and pull.
Tools Needed:
(1) Phillips Screwdriver
Basic American Medical products, a division of GF Health products, Inc. • Matrix II • rev d Manual | p11 |