At the Ground Controls, At the Platform Controls

Third Edition • Second Printing	Operator's Manual

1Select a test area that is firm, level and free of obstruction.

2Be sure the battery pack is connected.

At the Ground Controls

3Pull out the platform and ground red Emergency Stop buttons to the on position.

4Turn the key switch to ground control.

5Observe the diagnostic LED readout on the platform controls.

Result: The LED should look like the picture at right.

6Push in the ground red Emergency Stop button to the off position.

Result: No functions should operate.

7Pull out the red Emergency Stop button to the on position.

8 Activate the up function.

Result: The platform should raise.

9 Activate the down function.

Result: The platform should lower. The descent alarm should sound while the platform is lowering.

10 Activate the up function and raise the platform approximately 60 cm.

11Pull the manual lowering knob located at the base of the machine below the charger.

Result: The platform should lower. The descent alarm will not sound.

12 Turn the key switch to platform control.

FUNCTION TESTS

Test Emergency Stop

13Push in the platform red Emergency Stop button to the off position.

Result: No functions should operate.

14Pull out the red Emergency Stop button to the on position.

15Push the horn button.

Result: The horn should sound.

16Do not press the function enable switch on the control handle.

17Slowly move the control handle in the direction indicated by the blue arrow, then in the direction indicated by the yellow arrow.

Result: No functions should operate.

Test the Up/Down Functions

18 Press the lift function select button.

19 Press and hold the function enable switch on the control handle.

20Slowly move the control handle in the direction indicated by the blue arrow.

Result: The platform should raise.

21 Release the control handle.

Result: The platform should stop raising.

Part No. 97779

GR-12 • GR-15 • GR-20