Genie GR-15, GR-20, GR-12 manual Safety Rules, Do Not Operate Unless

Page 3

Third Edition • Second Printing

Operator's Manual

 

 

 

 

Safety Rules

Danger

Failure to obey the instructions and safety rules in this manual will result in death or serious injury.

Do Not Operate Unless:

You learn and practice the principles of safe machine operation contained in this operator's manual.

1 Avoid hazardous situations.

Know and understand the safety rules before going on to the next section.

2 Always perform a pre-operation inspection.

3 Always perform function tests prior to use.

4 Inspect the workplace.

5 Only use the machine as it was intended.

You read, understand and obey the manufacturer's instructions and safety rules— safety and operator's manuals and machine decals.

You read, understand and obey employer's safety rules and worksite regulations.

You read, understand and obey all applicable governmental regulations.

You are properly trained to safely operate the machine.

Part No. 97779

GR-12GR-15GR-20

1

Image 3
Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesAWP and fiberglass platform Electrocution HazardsMaximum capacity GR-12 and GR-15 Standard platform Stock Picker platformMaximum capacity GR-20 Standard platform Maximum slope rating, stowed positionMaximum side slope rating Stowed position Maximum allowable manual force Collision Hazards Fall HazardsDamaged Machine Hazards Crushing HazardComponent Damage Hazard Explosion and Fire HazardLifting Hazard Battery Safety Burn HazardsExplosion Hazards Tip-over HazardDecal Legend Page Platform Controls ControlsGround Control Panel Fundamentals Pre-operation InspectionPRE-OPERATION Inspection Pre-operation InspectionObserve and Obey MaintenanceMaintenance Symbols Legend Hydraulic oil specificationsCheck the Batteries Scheduled MaintenanceFunction Tests At the Platform Controls At the Ground ControlsTest the Steering Test Drive and BrakingTest the Tilt Sensor Operation Test the Pothole Guards Test Limited Drive SpeedWorkplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsOperation From Platform Emergency StopAuxiliary Lowering Operation From GroundDriving on a slope To Reduce Drive SpeedOperation From Ground with Controller Error Indicator displayBattery Level Indicator To Extend and Retract Platform if equippedStandard Batteries Battery and Charger Instructions Observe and ObeyMaintenance free batteries To Charge BatteriesBrake Release Operation Transport and Lifting InstructionsLoading the Machine With a Crane Securing to Truck or Trailer for TransitSecuring the Chassis Description Quantity DecalsDecals Inspection for Decals with Symbols Stock Picker Platform Decals Floor loading information SpecificationsGR-12 Drive speedsGR-15 SpecificationsGR-20 Platform dimensions, all models length x width Genie Scandinavia