Genie Official Manual for GR Models: Essential Safety and Operation Guidelines

Page 29

Third Edition • Second Printing

Operator's Manual

 

 

 

 

Loading the Machine With a Crane

Use the lifting eye mounted on the rear mast column.

Make sure the mast is fully lowered.

Inspect the machine and remove any loose or unsecured items.

Always place the lifting hook through the lifting eye so that it points away from the machine.

TRANSPORT AND LIFTING INSTRUCTIONS

Securing to Truck or Trailer for Transit

Always chock the machine wheels in preparation for transport.

Turn the key switch to the off position and remove the key before transporting.

Inspect the entire machine for loose or unsecured items.

Securing the Chassis

Use the tie-down points on the chassis for anchoring down to the transport surface.

Use chains or straps of ample load capacity.

Use a minimum of 4 chains.

Adjust the rigging to prevent damage to the chains.

Truck bed

1

3

2

4

Part No. 97779

GR-12GR-15GR-20

27

Image 29
Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesMaximum capacity GR-12 and GR-15 Standard platform Electrocution HazardsStock Picker platform AWP and fiberglass platformMaximum side slope rating Stowed position Maximum capacity GR-20 Standard platformMaximum slope rating, stowed position Maximum allowable manual force Collision Hazards Fall HazardsComponent Damage Hazard Crushing HazardExplosion and Fire Hazard Damaged Machine HazardsExplosion Hazards Battery Safety Burn HazardsTip-over Hazard Lifting HazardDecal Legend Page Platform Controls ControlsGround Control Panel Fundamentals Pre-operation InspectionPRE-OPERATION Inspection Pre-operation InspectionMaintenance Symbols Legend MaintenanceHydraulic oil specifications Observe and ObeyCheck the Batteries Scheduled MaintenanceFunction Tests At the Platform Controls At the Ground ControlsTest the Tilt Sensor Operation Test the SteeringTest Drive and Braking Test the Pothole Guards Test Limited Drive SpeedWorkplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsAuxiliary Lowering Emergency StopOperation From Ground Operation From PlatformDriving on a slope To Reduce Drive SpeedBattery Level Indicator Error Indicator displayTo Extend and Retract Platform if equipped Operation From Ground with ControllerMaintenance free batteries Battery and Charger Instructions Observe and ObeyTo Charge Batteries Standard BatteriesBrake Release Operation Transport and Lifting InstructionsSecuring the Chassis Loading the Machine With a CraneSecuring to Truck or Trailer for Transit Description Quantity DecalsDecals Inspection for Decals with Symbols Stock Picker Platform Decals GR-12 SpecificationsDrive speeds Floor loading informationGR-15 SpecificationsGR-20 Platform dimensions, all models length x width Genie Scandinavia