Genie GR-15, GR-20, GR-12 Maximum allowable manual force

Page 6

Operator's Manual

Third Edition • Second Printing

 

 

 

 

SAFETY RULES

Do not use the platform controls to free a platform that is caught, snagged or otherwise prevented from normal motion by an adjacent structure. All personnel must be removed from the platform before attempting to free the platform using the ground controls.

Do not push off or pull toward any object outside of the platform.

Maximum allowable manual force

CE 200 N

Do not transport tools and materials unless they are evenly distributed and can be safely handled by person(s) in the platform.

Do not alter or disable machine components that in any way affect safety and stability.

Do not modify or alter an aerial work platform without prior written permission from the manufacturer. Mounting attachments for holding tools or other materials onto the platform, toeboards or guard rail system can increase the weight in the platform and the surface area of the platform or the load.

Do not raise the mast when wind speeds may exceed 12.5 m/s. If wind speeds exceed 12.5 m/s when the plaform is raised, lower the platform and do not continue to operate the machine.

Do not operate the machine in strong or gusty winds. Do not increase the surface area of the platform or the load. Increasing the area exposed to the wind will decrease machine stability.

Do not drive the machine on or near uneven terrain, unstable surfaces or other hazardous conditions with the platform raised.

Do not replace items critical to machine stability with items of different weight or specification.

Do not use the machine on a moving or mobile surface or vehicle.

Do not place or attach fixed or overhanging loads to any part of this machine.

Do not place ladders or scaffolds in the platform or against any part of this machine.

Be sure all tires are in good condition, castle nuts are properly tightened and cotter pins are properly installed.

4

GR-12GR-15GR-20

Part No. 97779

Image 6
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessStock Picker platform Electrocution HazardsMaximum capacity GR-12 and GR-15 Standard platform AWP and fiberglass platformMaximum capacity GR-20 Standard platform Maximum slope rating, stowed positionMaximum side slope rating Stowed position Maximum allowable manual force Fall Hazards Collision HazardsExplosion and Fire Hazard Crushing HazardComponent Damage Hazard Damaged Machine HazardsTip-over Hazard Battery Safety Burn HazardsExplosion Hazards Lifting HazardDecal Legend Page Controls Platform ControlsGround Control Panel Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionHydraulic oil specifications MaintenanceMaintenance Symbols Legend Observe and ObeyScheduled Maintenance Check the BatteriesFunction Tests At the Ground Controls At the Platform ControlsTest the Steering Test Drive and BrakingTest the Tilt Sensor Operation Test Limited Drive Speed Test the Pothole GuardsWorkplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedOperation From Ground Emergency StopAuxiliary Lowering Operation From PlatformTo Reduce Drive Speed Driving on a slopeTo Extend and Retract Platform if equipped Error Indicator displayBattery Level Indicator Operation From Ground with ControllerTo Charge Batteries Battery and Charger Instructions Observe and ObeyMaintenance free batteries Standard BatteriesTransport and Lifting Instructions Brake Release OperationLoading the Machine With a Crane Securing to Truck or Trailer for TransitSecuring the Chassis Decals Description QuantityDecals Inspection for Decals with Symbols Stock Picker Platform Decals Drive speeds SpecificationsGR-12 Floor loading informationSpecifications GR-15GR-20 Platform dimensions, all models length x width Genie Scandinavia