Toshiba manual Remote Connection, Stratagy Admin PC Modem, Stratagy IVP8 Modem

Installation

Step 8: Connect Stratagy Admin PC to Stratagy IVP8

Remote Connection

Remote communication with the Stratagy IVP8 requires the installation of a modem on the Stratagy Admin PC (if a modem does not already exist). The Stratagy IVP8 comes equipped with an internal modem of 2400 baud and does not require any additional equipment. A 9600 baud external modem can also be used for remote connection with the Stratagy IVP8.

Stratagy Admin PC Modem

➤Prepare the Stratagy Admin PC by installing, connecting and configuring a modem. The modem must be capable of communicating at a minimum of 9600 baud.

CAUTION! Internal modems configured for COM ports 3 or 4 are not supported by Stratagy Admin software.

Stratagy IVP8 Modem

The Stratagy IVP8 can communicate through either an internal or external modem.

Internal

The Stratagy IVP8 has an internal modem that communicates at up to 2400 baud. No additional equipment is necessary. (See KM token in Step 13: “Program the Applications” on page 27 for programming information.)

External

An external modem can be installed on the Stratagy IVP8 for a communication speed of 9600 baud. If use of an external modem is desired, use the following installation procedure.

➤To install an external modem

1.Equip the Stratagy IVP8 with a Hayes-compatible 14.4KB V32.bis modem. Toshiba’s fax/modem (SG-FMOD) has been tested for consistent operation and is recommended. Use of other modem models cannot be guaranteed for trouble-free operation.

Note The default setting configured for the Stratagy IVP8 remote access is serial port 2 (see Figure 1). Both local and remote access use the same designated serial port on the Stratagy IVP8.

2.Connect a telephone line to the modem. Use either a station connected to the telephone system or a dedicated Central Office (CO) line.

Stratagy IVP8 Installation Guide 01/02 17