Stratagy IVP8 Slot Assignments DK424i/DK424

Toshiba manual Stratagy IVP8 Slot Assignments DK424i/DK424

Installation

Step 4: Install Stratagy IVP8

Table 1 Stratagy IVP8 Slot Assignments

DK424i/DK424

Note For the DSS/BLF feature, the Stratagy IVP8 must reside in a higher-numbered slot than the PDKU card that the Stratagy IVP8 monitors (see Figure 2 on page 14).

Install the card in a universal slot starting with slot 12 (if a PDKU or PEKU is in slot 11) or slot 13 (if a RSIU is in slot 11).

Important! Do not install the Stratagy IVP8 in slots 27, 28, 31, 37, 38, 47, 48, 51, 57, 58, 67, 68, 71, 77, or 78.

To enable end-to-end signaling, ensure that an RRCS -4, -8 or -12 is installed on the RCTU, and verify that the RCTU code in Program 03 is for RRCS operation.

DK280

Important! The Stratagy IVP8 does not function when installed in slots 31 or 51.

Note For the DSS/BLF feature, the Stratagy IVP8 must reside in a higher-numbered slot than the PDKU card that the Stratagy IVP8 monitors (see Figure 2 on page 14).

DK280 (R2) — install the card in any universal slot (except slots 31 and 51), starting with slot 12 of the Base Cabinet.

DK280 (R3 or higher) — install the card in any universal slot (except slots 31 and 51), starting with slot 12 (if a PDKU or PEKU is in slot 11) or slot 13 (if a RSIU is in slot 11).

DK280 (All releases) — To enable end-to-end signaling, an RRCS -4, -8 or -12 must be installed on the RCTU. Verify that the RCTU code in Program 03 is for RRCS operation.

DK40i/DK40/DK16e/DK16

Install the Stratagy IVP8 in any slot in the Expansion KSU where an eight-port card can be inserted. For DK40i/DK40/DK16e, see Chapter 2 – DK40i Configuration in the Strata DK I&M Manual for all possible configurations.

Important! Do not install Stratagy IVP8 in slot 18 of the DK40i/DK40/DK16e.

DK40i/DK40/DK16e/DK16: A K5RCU, K5RCU2, or K4RCU3 must be installed in the Base KSU to enable end-to-end signaling.

Note Putting a Stratagy IVP8 into a Strata DK40i/DK40/DK16e/DK16, eliminates eight telephone lines.

DK24, DK56, DK96

Install the card in any slot after slot 01. A CRCU must be installed to enable end-to-end signaling.

DSS/Busy Lamp Feature (For all Strata DK systems)

For the DSS/Busy Lamp feature to operate, the Stratagy IVP8 must monitor the DSS/BLF data from a specific PDKU card. The Strata DK telephone system restricts this capability to certain configurations. The Stratagy IVP8:

•

Cannot be installed in the first slot of any cabinet (i.e., 11~71).

Can only monitor a PDKU that resides in an odd-numbered cabinet.

Must always be in a higher-numbered slot than the PDKU card, even if the PDKU is in another cabinet.

When Stratagy IVP8 is installed in an odd-numbered cabinet, the system software searches for the PDKU in all lower-numbered card slots in that cabinet (as defined by the console_slot_id parameter on page 25). When the Stratagy IVP8 is installed in an even-numbered cabinet, the system software searches for the PDKU in all lower-numbered card slots of the preceding odd-numbered cabinet. see Figure 2 on page 14 for examples.

Stratagy IVP8 Installation Guide 01/02