Lucent Technologies MDW 9031DCP manual Battery Problems

Page 117

Procedures

 

Troubleshooting 5

 

 

 

Battery Problems

Symptom

Possible Causes

Possible Solutions

 

 

 

Battery icon appears in

This is normal operation for the

No action is required.

the handset display.

MDW 9031 Pocket Phone.

 

 

 

 

Battery icon flashes in

Battery power is low.

You have 5 minutes or less of talk

the handset display and

 

time left. Either:

the handset beeps twice.

 

Complete your call, turn the

 

 

 

 

handset off, and recharge the

 

 

battery pack.

 

 

If you have a fully charged

 

 

spare battery pack, place your

 

 

call on Hold. Swap the battery

 

 

packs. Wait 6 to 10 seconds,

 

 

then turn the handset on and

 

 

proceed as you would for any

 

 

call placed on Hold.

 

 

 

Handset battery pack

Battery pack needs to be refreshed.

When the Battery icon flashes,

does not last as long as

 

insert the handset with its battery

it used to under similar

 

into the handset cradle and press the

conditions.

 

REFRESH button, or insert the

 

 

handset battery pack into the spare

 

 

battery compartment until the

 

 

SPARE LED is steady green.

 

 

 

You get less than 3

Battery pack needs to be refreshed a

Refresh the battery pack.

hours of talk time when

second time.

 

you use a standard

 

 

battery pack that was

 

 

refreshed.

 

 

 

 

 

You get less than 8

Battery pack needs to be refreshed a

Refresh the battery pack.

hours of talk time when

second time.

 

you use an extended

 

 

battery pack that was

 

 

refreshed.

 

 

 

 

 

When a battery pack or

Battery pack may have

Try a different battery pack if you

the handset with battery

malfunctioned.

have one.

pack is placed in the

 

Call for Customer Support.*

charger, the appropriate

 

 

 

LED (SPARE or

 

 

HANDSET) does not

 

 

light.

 

 

 

 

 

*See “Customer Support” in the Copyright and Legal Notices at the beginning of this book

MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166

Issue 3 October 1999 109

Image 117
Contents TransTalk Digital Wireless System Page Copyright and Legal Notices Copyright and Legal Notices Contents Contents Using the MDW 9031/9031DCP Pocket PhoneAppendix B Regulatory Information 143 Vi Issue 3 October Introduction What Is a Wireless Phone?About TransTalk 9000 Products TransTalk 9000 SystemIntroduction About TransTalk 9000 Products Multiple 5 Max Carrier InstallationAbout the MDW 9031/9031DCP Pocket Phone Where Can You Use Your Pocket Phone?Privacy Information About the MDW 9031/9031DCP Pocket Phone IntroductionIntroduction About the MDW 9031/9031DCP Pocket Phone Parts ListTranstalk Additional PartsSpare Battery and Headset Installing the MDW 9031/9031DCP Pocket Phone Important Safety InstructionsGuidelines for Safe and Efficient Operation Basic Safety Precautions for Installation and Use Page Additional Safety Instructions for Installation Personnel AC Outlet Check Installation Overview for Radio Modules and Carriers Radio Module/Switch WiringSwitch Interface Pin # Pass Key ComponentsOUT of Sync LED CONTROL/EXPANSION LED Positioning a Radio Module or Carriers Radio module cannot be installed outdoors Carriers Installing a Single Radio ModuleInstalling a Single Radio Module Dio Single Radio Module Installation Self-Test Understanding Your Model 117A3 Carrier Understanding CarriersPower DIP Control/Expansion Setting the 117A3 Desired Range approximate Power DIP Switch Settings Setting the 117A3 Carrier Control/Expansion DIP Switch Issue 3 October CONTROL/EXPANSION LED Understanding Your Model 117A4 CarrierLabel Explanation Control carrier = green LEDExpansion carrier = amber LED Page Installing a Single Carrier Installing a Single Carrier on a Shelf or Desk Installing the MDW 9031/9031DCP Pocket Phone Page Music Go to Single Carrier Installation Self-Testpage Installing a Single Carrier on a Wall Page Music Go to Single Carrier Installation Self-Testpage Control Single Carrier Installation Self-TestInstalling Multiple Carriers Mounting and Cabling Multiple Carriers From Control Carrier Issue 3 October If the carriers are plugged Then Into Multiple Carrier Mounting and Cabling Self-Test Go to Installing a Single Radio Module in Each Carrier Installing a Single Radio Module in Each Carrier Page If the carriers are plugged Then Into 117A4 117A3 Control Go to Installing the Remaining Radio Modules Installing the Remaining Radio Modules Page Music Go to Installation Self-Test for Remaining Radio Modules Installation Self-Test for Remaining Radio Modules Go to Handset Inserting and Removing the Handset’s Battery Pack Installing the MDW 9031/9031DCP Pocket Phone HandsetHandset Handset Installing the MDW 9031/9031DCP Pocket Phone Changing the Communications System SettingMapp Filling Out the Handset Label Battery Charger Positioning the Battery ChargerInstalling the Battery Charger Battery Charger Installing the MDW 9031/9031DCP Pocket Phone Inserting a Battery Pack into the Spare Battery Compartment Removing a Battery Pack from the Spare Battery Compartment Removing the Handset from the Handset Cradle Guide PinsUsing the MDW 9031/9031DCP Pocket Phone Handset Controls Using the MDW 9031/9031DCP Pocket Phone HandsetColumn and Select Buttons Handset Using the MDW 9031/9031DCP Pocket PhoneHandset Display with Backlighting MSG Range onLclp Or fully extended for maximum range to use the Pocket Phone RectangleCarrying Your Pocket Phone Volume ControlAttaching the Metal Carrying Clips Antenna Changing the Handset SettingsChanging Communications System Button Mapping Setting Enabling or Disabling Line Preselection Enabling or Disabling Backlighting Enabling or Disabling the Alerter Test Modes Using Local Test ModeUsing Wireless Test Mode Display Number Signal Strength Is Display Number Voice Quality Is Close Up Test Waking Up the Phone Making a Call Answering a CallManually Selecting a Line or Programmed Button Accessing Certain Voice Mail Systems with a Definity System Using a HeadsetPreselecting a Line Headset Battery Charger Using the MDW 9031/9031DCP Pocket Phone Battery Charger FeaturesUsing the MDW 9031/9031DCP Pocket Phone Battery Charger Extending Battery LifePage Using the MDW 9031/9031DCP Pocket Phone Battery Charger Removing Radio Module from Carrier Maintaining the MDW 9031/9031DCP Pocket PhoneMaintaining the MDW 9031/9031DCP Pocket Phone Control Swapping Extensions Control Replacing Antenna Ordering Replacement and Optional PartsNational Parts Lucent Direct Sales Center PartPage Ordering Replacement and Optional Procedures TroubleshootingInstallation Problems Troubleshooting ProceduresSymptom Possible Causes Possible Solutions Power LED ~ OUT of Sync = all lit ~ OUT of Sync = not lit~ CONTROL/EXPANSION = all lit Procedures Troubleshooting Handset ProblemsChange Buttn Battery Problems Issue 3 October Check Control Voice Quality ProblemsSymptom Possible Causes Possible Solutions PARTNER, Partner Range Problems Each radio module light when Been Placed on Hold Module. Your Call has notBattery Charger Problems Symptoms Possible Causes Possible SolutionsHandset LED on Handset LED Handset LED does Troubleshooting Procedures MDW 9031/9031DCP Pocket Phone Compatibility OverviewMDW 9031 Compatibility Partner Partner Merlin Communications System CompatibilityPartner Systems Button Mapping for Partner Systems Carriers one control and two To Delayed RingSystem Expansion carriersIssue 3 October Recall Button Mapping for Merlin 410 and Merlin 820 Systems Definity G1 R1V4 Ring To Delayed RingAccessing Certain Voice Mail Systems with a Definity System Drop BCC SPE B Issue 3 October MDW 9031DCP Compatibility Programming Features for Definity SystemsSPE B Station Feature Options Programmable buttons buttons 1-7. Button 8 is a firmware Feat/P 9031DCP Pocket Phones with Definity Systems Issue 3 October Warranty and Repair Information Post-Warranty Repairs In-Warranty RepairsWarranty and Repair Information Repair InformationFCC Part 15 Rules Regulatory InformationIC RSS-210 Compliance Hearing Aid CompatibilityRegulatory Information Hearing Aid Compatibility MDW 9031/9031DCP Wireless Pocket Phone SpecificationsSpecifications General Index Index Index Index Vibr Index Battery Charger Wall-Mounting Template
Related manuals
Manual 12 pages 23.19 Kb