Lucent Technologies MDW 9031DCP manual Handset LED does

Procedures Troubleshooting 5

Symptoms	Possible Causes	Possible Solutions
SPARE LED on battery	Battery pack is defective.	If you have a battery pack in the
charger flashes red.		handset and one in the spare battery
		compartment, remove both battery
		packs from the charger to clear the
		red flashing LED. Then test each
		battery pack separately as follows:
		1 Insert the battery pack in the
		handset and place the handset in
		the battery charger’s handset
		cradle.
		2 Wait one minute. If the
		HANDSET LED flashes red,
		order a new battery pack.
	Contacts on the battery pack or in the	1 Verify that there are no
	battery charger’s spare battery	obstructions on the battery pack
	compartment are dirty.	or battery charger contacts.
		2 Unplug the charger and clean
		the contacts with a soft eraser.
		3 Clean the battery pack contacts
		with a soft eraser.
	Battery pack is not seated properly in	Reseat the battery pack in the
	the spare battery compartment.	battery charger’s spare battery
		compartment, as described in
		Chapter 3.
Handset is in the battery	Handset is not seated properly in the	Reseat the handset in the battery
charger cradle and the	battery charger cradle.	charger cradle.
HANDSET LED does	Battery power supply is not plugged	Check that the charger power cord
not light.
	in.	is plugged into the charger and into
		an electrical outlet that is not
		controlled by a wall switch.

MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166 Issue 3 October 1999 119