Lucent Technologies MDW 9031DCP manual Installing a Single Radio Module, Carriers

Installing a Single Radio Module Installing the MDW 9031/9031DCP Pocket Phone 2

Additional Rules for	• Install carrier(s) within 15 feet (5 m) of either side of, and within 6 to 8 feet (1.8
Installing One or More	to 2.4 m) above, a properly grounded, 3-prong electrical outlet that is not
Carriers
	controlled by an on/off switch.
	• Choose a location where handset users will not approach the carrier(s)
	within a radius of 6 feet (1.8 m) for 1 or 2 carriers or 10 feet (3 m) for 3
	carriers.
	• When installing multiple carriers:
	~ Install multiple carriers 1 foot (0.3 m) optimally to 4 feet (1.2 m) apart.
	~ Install multiple carriers on the same horizontal axis (do not install one carrier
	higher or lower than another).
	~ Install the control carrier as the leftmost carrier, using only the expansion
	cables provided.
	~ Slot 6 of an 117A3 control carrier must always contain a radio module to pass
	the synchronization signal to the next carrier.

! CAUTION:

Carrier(s) cannot be installed outdoors.

Go to “Using Wireless Test Mode” in Chapter 3.

Installing a Single Radio Module

•Install a single radio module high on a wall, leaving 6 to 12 inches (15.2 to 30.5 cm) between the top of the antenna and the ceiling.

•See “Key Components” earlier in this chapter for additional picture detail.

To install a single radio module:

1Perform the tests described in “Using Wireless Test Mode” in Chapter 3 to determine the optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.

2Check to be sure the radio module’s power cord is unplugged from the wall outlet before continuing.

MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166 Issue 3 October 1999 17