Lucent Technologies MDW 9031DCP manual If the carriers are plugged Then Into

2 Installing the MDW 9031/9031DCP Pocket Phone Installing Multiple Carriers

7Insert the free end of each telephone line cord into the appropriate extension jack or terminal/station connector on your communications system switch/control unit (refer to your communications system manual for the proper location).

N	X
S	T
I	E
O	N
N	S
S	I	MUSIC
	O
		ON
	N	HOLD
	S

8Power the carriers as follows:

If the carriers are plugged	Then...
into...
one surge suppressor strip	Power the strip.
	Result: All the carriers will turn on simultaneously.
wall outlets	Plug in the power for the carriers in this order:

1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6

Control	Expansion	Expansion	Expansion	Expansion
Carrier	Carrier #1	Carrier #2	Carrier #3	Carrier #4
1	2	3	4	5

!CAUTION:

Never connect or disconnect expansion cables or telephone line cords, or insert or remove radio modules, while the carrier is plugged into the wall outlet.

Keep in mind that a Model 117A3 control carrier must have a module in Slot 6 in order to synchronize correctly with the remaining carrier(s).

9Go to “ Installation Self-Test with a Single Radio Module in Each Carrier” (page 51).

50 Issue 3 October 1999 MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166