EN
5.Insert screws from the INSIDE of the cabinet. If you did not countersink the drilled holes, position the washers, flat side down, and place the screws in the holes.
If your cabinet does not have an overhang, go to Step 7.
6.Hold the screw heads down while you push the selected spacers onto the screws under the cabinet. Be sure to push spacers until they are firmly against the cabinet bottom and/or fully nested (if more than one is used).
7.Align the unit under the screws. Hold the screw holes on the top of the unit against the mounting screws and partially tighten the screws.
TIP: Do not fully tighten until all 4 screws are installed.
8.Extend the cord towards an electrical outlet and secure by using the cord hooks to hold the cord out of the way. For a more attractive appearance, place the cord hooks at the back edge of the cabinet (on or next to wall) directly over the electrical outlet to be used.
To attach cord hooks peel off the adhesive on the back of the hooks and attach to a clean, dry surface on the underside of the cabinet or back wall.
Cord hooks
11
14 | 5/20/2005, 12:09 PM |