Oregon Scientific OS6976 Troubleshooting Tips, Connecting the Belt Clip, Caller ID, Telephone

EN

CONNECTING THE BELT CLIP

There are two slots, one on each side of the handset.
• Attach the belt clip by inserting the sides of the belt clip	slots for	slots for
into the slots. Snap the ends of the belt clip into place.	belt clip	belt clip

TROUBLESHOOTING TIPS

CALLER ID

No Display

•Check or replace the handset battery pack.

•Make sure the unit is connected to a non-switched electrical outlet. Disconnect the unit from the plug and plug it in again.

•You must subscribe to Caller ID service from your local telephone company to receive CID information.

Caller ID Error Message

•The unit displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates the presence of noise on the line.

TELEPHONE

No dial tone

•Check or repeat installation steps:

•Make sure the wall base unit is correctly plugged into the electrical outlet. Make sure power cords are connected to working electrical outlets.

Make sure the telephone line cord is connected to the telephone line jacks (at the wall base unit and the wall).

•Disconnect the wall base unit from the wall telephone jack and connect another phone to the same jack. If there is no dial tone in the second phone, the problem might be your wiring or local service.

•Handset or Kitchen Companion may be out of range from the wall base unit. Move closer to wall base unit.

•Make sure the handset battery is properly charged (12 hours).

•Make sure the handset battery pack is correctly installed.

•Did the handset beep when you pressed the TALK/CALLBACK button? Did the display indicator turn on? The battery may need to be charged.

37

os6976-en1.p65 40 5/20/2005, 12:09 PM