Oregon Scientific OS6976 user manual Charging the Battery, Display Messages

EN

CHARGING THE BATTERY

Make sure the telephone is OFF before you replace battery.

1.Remove the battery compartment door.

2.Disconnect the battery plug from the jack in the handset battery compartment and remove the battery pack.

3.Connect the plug of the new battery pack into the jack inside the handset, and then insert the new battery pack into the compartment.

4.Close the battery compartment by pushing the cover up until it snaps into place.

5.Place handset in the Charge to charge. Allow the handset battery to properly

charge (for 12 hours) prior to first use or when you install a new battery pack. If you do not properly charge the phone, battery performance will be compromised.

CAUTION: To reduce the risk of fire or personal injury, use only Oregon Scientific’s battery .

DISPLAY MESSAGES

The following indicators show the status of a message or of the unit.

INCOMPLETE DATA	Caller information has been interrupted during transmission or the phone
	line is excessively noisy.
ENTER NAME	Prompt telling you to enter the name for one of the 10 memory locations.
ENTER TEL NUMBR	Prompt telling you to enter the telephone number for one of the 10
	memory locations.
PRESS AND HOLD	Prompt telling you to re-register the handset or the Kitchen Companion
FORMAT KEY	to the wall base unit.
PRESS AND HOLD	Indicates to press the page button on the wall base unit to complete the
BASE PAGE KEY	registration of either the handset or the Kitchen Companion.
DELETE?	Prompt asking if you want to erase Caller ID records or one of the 10
	numbers stored in the phone’s outgoing memory.
DELETE ALL?	Prompt asking if you want to erase all Caller ID records.
DELETED	Prompt confirming the Caller ID /Memory record is erased.
END OF LIST	Indicates that there is no additional information in Caller ID memory.
BLOCKED NUMBER	The callers telephone number is blocked from transmission.
LINE IN USE	Indicates that either the handset or the Kitchen Companion or another
	phone connected to the same line is in use.
NEW	Indicates call or calls have not been reviewed.
UNKNOWN NAME/	The incoming call is from an area not serviced by
CALLER/NUMBER	Caller ID or the information was not sent.
PAGING	Someone has pressed the page button on the base.
BLOCKED CALL	The call information is blocked from transmission.

35

os6976-en1.p65 38 5/20/2005, 12:09 PM