Oregon Scientific OS6976 user manual Os6976-en1.p65 20/2005, 1209 PM

Dial tone is OK, but can't dial out

•Make sure the tone/pulse setting is programmed correctly.

Handset does not ring

•Make sure the ringer switch on the handset is turned to ON.

•You may have too many extension phones on your line. Try unplugging some phones.

•See solutions for “No dial tone.”

Handset or Kitchen Companion loses registration ID

•If the handset or Kitchen Companion becomes unregistered, PRESS AND HOLD BASE PAGE KEY shows in the display to prompt you to re-register the handset or the charge until the wall base unit restores the registration ID.

•If registration is not successful, unplug the wall base unit from the electrical outlet and re-plug it after a few seconds to reset the unit.

You experience static, noise, or fading in and out

•Change channels

•Handset or Kitchen Companion may be out of range of wall base unit. Move closer to wall base unit.

•Relocate the wall base unit.

•Charge the battery.

•Make sure wall base unit is not plugged into an outlet with another household appliance.

Handset beeps

•Place handset in to the Kitchen Companion charge cradle to reset. If that doesn’t work, charge battery for 12 hours.

•See solutions for “No dial tone.”

•Replace battery.

Kitchen Companion beeps

•Disconnect the power supply, wait for 2 minutes and re-connect it to reset.

•See solutions for “No dial tone”.

Memory Dialing

•Did you program the memory location keys correctly?

•Did you follow proper dialing sequence?

•Make sure the tone/pulse setting is programmed correctly.

•Did you reprogram numbers into memory after power outage or battery replacement?

38

EN

os6976-en1.p65 41 5/20/2005, 12:09 PM