Radio Shack 43-3872 manual On a Desk Top, You must use

Page 10

Installation

CAUTION

You must use

!a Class 2 power source

that supplies 9V DC and delivers at least 350 mA. Its center tip must be set to positive and its plug must fit the phone’s DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.

On a Desk Top

1.Insert the two tabs at the top of the narrow end of the supplied bracket into the base’s upper tab slots, then press down on the bracket’s latches and insert them into the lower slots.

2.Connect the handset cord to left side of the phone and corded handset.

3.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the base.

4.Plug the modular cord’s other end into a modular phone line jack.

5.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.

6.Route the adapter’s cord through the strain relief slot on the base, then plug the adapter into a standard AC outlet.

7.Lift the base’s antenna to a vertical position.

10

Image 10

Contents 4GHz Expandable Corded/Cordless Phone Answerer Contents Introduction Information FCC StatementImportant Information Surge Protection Important Safety Instructions Read this Before Installation Important Caller ID InformationInstallation Selecting a LocationOn a Desk Top You must useOn a Wall Plate or Wall Using AC Power CONNECTING/CHARGING the Battery Pack Recharging the Battery Pack To attach the beltclip Installing the BeltclipUsing a Headset To remove the beltclipExample of the standby mode display Handset Display and IconsSoft KEY Functions Base 570#Setting Menu Options Using the InterfaceUsing Room/Monitor DirectLink ModeUsing DirectLink Mode Handset only Room/Baby MonitorHandset Setup/Base Setup Selecting a Ringer ToneDistinctive Ringer Setup Setting the Anykey Answer Handset only Selecting a LanguageSetting the Key Touch Tone Setting Day and Time Global SetupSetting Cidcw Caller ID on Call Waiting Setting the Area Code Setting the Dial ModeSystem Reset Handset only De-register the HandsetPlace handset on main base Handset RegistrationMaking a Call Using Your PhonePower Failure Operation From the handsetFrom the Handset Speakerphone Receiving a CallFrom the base Hanging UP Switching to Speakerphone During a CallCall Waiting Placing a Call on Hold RedialingAdjusting the RINGER, Earpiece and Speaker Volume Ringer volumeEarpiece and Speaker Volume Audio Tones Base onlyTemporarily Muting the Ringer Do Not Disturb DNDMuting the Ringer Tone Dialing SWITCH-OVER Mute MicrophoneTraveling OUT Range Booster Handset OnlyConferencing Privacy ModeJoining a Conference Call Speed Dialing Find HandsetFrom a second handset Phonebook PhonebookIf you make a mistake while entering a name Store/Edit No. appears Storing Caller ID Messages in the Phonebook Storing a Redial RecordDeleting a Redial Record Viewing the PhonebookMaking Calls Using the Phonebook From Standby Mode Deleting ALL Phonebook Locations Base only From the handset Copying Phonebook LocationsTesting Stored Emergency Number From the baseCaller ID and Cidcw Caller ID on Call Waiting Incomplete DataCall Waiting Deluxe Features Viewing the Caller ID List Deleting Information from the Caller ID List Deleting ALL Caller ID NAME/NUMBERSFrom Talk mode From Standby ModeCalling a Party from the Caller ID List Four Multi-Handset Expandability Expanding Your PhoneRegister the Handset to the Base Using the Directlink Mode DirectLink callFOUR-WAY Conferencing INTERCOM/CALL Transfer FeatureIntercom Making an Intercom From a handsetCall Transfer Feature Answering an IntercomAnswering a Call Transfer To answer a page from a handsetAccepting the call transfer To answer a page from the baseFeatures Integrated Answering DeviceRecord a Personal Outgoing Message Base Only Answering System SetupSelecting Your Greeting Base only Setting a PIN Code Setting the Ring TimeSetting the Record Time Setting the Message Alert On or OffTurning the message alert tone off by pressing any key Setting the Language of your Answering SystemSetting the Call Screen Turning the message alert tone off from a remote locationUsing Your Answering System Turning the Answering System ON/OFFPlaying your messages New Message LEDRepeating a message Skipping a message Deleting a message Voice memo Recording a conversationRemote access away from home Remote OperationFunction Remote Key Function Remote access with the handsetAnsweringMachine operation appears on the base Integrated Answering Device Troubleshooting Symptom SuggestionKeep the handset away from microwave ovens Service and Repair CareMemo RadioShack Corporation