Radio Shack 43-3872 manual Care, Service and Repair

Page 74

Symptom

Suggestion

 

 

No sound on the base unit

• Adjust the speaker volume on the base unit.

speaker during call

monitoring or message

• Make sure the call screen feature is set to On.

playback.

 

 

• Make sure you are using the correct PIN number.

Cannot access remote call-

• Make sure that the touch-tone phone you’re

in features from another

using can transmit the tone for at least two

touch-tone phone.

seconds. If it cannot, you may have to use

 

another phone to access your phone.

Time stamp cannot be

• Make sure you have set the time (see “Setting

heard.

Day and Time” on Page 24).

If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the problem, take the phone to your local RadioShack store for assistance.

CARE

Keep the phone dry; if it gets wet, wipe it dry immediately. Use and store the phone only in normal temperature environments. Handle the phone carefully; do not drop it. Keep the phone away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.

SERVICE AND REPAIR

If your phone is not performing as it should, take it to your local RadioShack store for assistance. To locate your nearest RadioShack, use the store locator feature on RadioShack’s website (www.radioshack.com), or call 1-800-The Shack (843-7422) and follow the menu options. Modifying or tampering with the phone’s internal components can cause a malfunction and might invalidate its warranty and void your FCC authorization to operate it.

Care

74

Image 74
Contents 4GHz Expandable Corded/Cordless Phone Answerer Contents Introduction Information FCC StatementImportant Information Surge Protection Important Safety Instructions Read this Before Installation Important Caller ID InformationInstallation Selecting a LocationOn a Desk Top You must useOn a Wall Plate or Wall Using AC Power CONNECTING/CHARGING the Battery Pack Recharging the Battery Pack To attach the beltclip Installing the BeltclipUsing a Headset To remove the beltclipExample of the standby mode display Handset Display and IconsSoft KEY Functions Base 570#Setting Menu Options Using the InterfaceUsing Room/Monitor DirectLink ModeUsing DirectLink Mode Handset only Room/Baby MonitorHandset Setup/Base Setup Selecting a Ringer ToneDistinctive Ringer Setup Setting the Anykey Answer Handset only Selecting a LanguageSetting the Key Touch Tone Setting Cidcw Caller ID on Call Waiting Global SetupSetting Day and Time Setting the Area Code Setting the Dial ModeSystem Reset Handset only De-register the HandsetPlace handset on main base Handset RegistrationMaking a Call Using Your PhonePower Failure Operation From the handsetFrom the base Receiving a CallFrom the Handset Speakerphone Call Waiting Switching to Speakerphone During a CallHanging UP Placing a Call on Hold RedialingAdjusting the RINGER, Earpiece and Speaker Volume Ringer volumeEarpiece and Speaker Volume Audio Tones Base onlyMuting the Ringer Do Not Disturb DNDTemporarily Muting the Ringer Tone Dialing SWITCH-OVER Mute MicrophoneTraveling OUT Range Booster Handset OnlyJoining a Conference Call Privacy ModeConferencing From a second handset Find HandsetSpeed Dialing Phonebook PhonebookIf you make a mistake while entering a name Store/Edit No. appears Storing Caller ID Messages in the Phonebook Storing a Redial RecordDeleting a Redial Record Viewing the PhonebookMaking Calls Using the Phonebook From Standby Mode Deleting ALL Phonebook Locations Base only From the handset Copying Phonebook LocationsTesting Stored Emergency Number From the baseCaller ID and Cidcw Caller ID on Call Waiting Incomplete DataCall Waiting Deluxe Features Viewing the Caller ID List Deleting Information from the Caller ID List Deleting ALL Caller ID NAME/NUMBERSCalling a Party from the Caller ID List From Standby ModeFrom Talk mode Register the Handset to the Base Expanding Your PhoneFour Multi-Handset Expandability Using the Directlink Mode DirectLink callFOUR-WAY Conferencing INTERCOM/CALL Transfer FeatureIntercom Making an Intercom From a handsetCall Transfer Feature Answering an IntercomAnswering a Call Transfer To answer a page from a handsetAccepting the call transfer To answer a page from the baseFeatures Integrated Answering DeviceSelecting Your Greeting Base only Answering System SetupRecord a Personal Outgoing Message Base Only Setting a PIN Code Setting the Ring TimeSetting the Record Time Setting the Message Alert On or OffTurning the message alert tone off by pressing any key Setting the Language of your Answering SystemSetting the Call Screen Turning the message alert tone off from a remote locationUsing Your Answering System Turning the Answering System ON/OFFRepeating a message New Message LEDPlaying your messages Skipping a message Deleting a message Voice memo Recording a conversationRemote access away from home Remote OperationFunction AnsweringMachine operation appears on the base Remote access with the handsetRemote Key Function Integrated Answering Device Troubleshooting Symptom SuggestionKeep the handset away from microwave ovens Service and Repair CareMemo RadioShack Corporation