Radio Shack 43-3872 manual Information, FCC Statement

Page 4

Important Information

Ô NOTE Ô

You must not connect your phone to:

coin-operated systems

most electronic key telephone systems

IMPORTANT

INFORMATION

This telephone has been tested and found to comply with all applicable UL and FCC standards.

FCC STATEMENT

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the base of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.

Your phone is not intended to be used with party-line systems. Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission, or corporation commission for information. Ô

The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0).

To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company.

For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.

4

Image 4
Contents 4GHz Expandable Corded/Cordless Phone Answerer Contents Introduction Information FCC StatementImportant Information Surge Protection Important Safety Instructions Read this Before Installation Important Caller ID InformationInstallation Selecting a LocationOn a Desk Top You must useOn a Wall Plate or Wall Using AC Power CONNECTING/CHARGING the Battery Pack Recharging the Battery Pack Installing the Beltclip Using a HeadsetTo attach the beltclip To remove the beltclipExample of the standby mode display Handset Display and IconsSoft KEY Functions Base 570#Setting Menu Options Using the InterfaceDirectLink Mode Using DirectLink Mode Handset onlyUsing Room/Monitor Room/Baby MonitorHandset Setup/Base Setup Selecting a Ringer ToneDistinctive Ringer Setup Setting the Anykey Answer Handset only Selecting a LanguageSetting the Key Touch Tone Setting Day and Time Global SetupSetting Cidcw Caller ID on Call Waiting Setting the Area Code Setting the Dial ModeSystem Reset Handset only De-register the HandsetPlace handset on main base Handset RegistrationUsing Your Phone Power Failure OperationMaking a Call From the handsetFrom the Handset Speakerphone Receiving a CallFrom the base Hanging UP Switching to Speakerphone During a CallCall Waiting Placing a Call on Hold RedialingRinger volume Earpiece and Speaker VolumeAdjusting the RINGER, Earpiece and Speaker Volume Audio Tones Base onlyTemporarily Muting the Ringer Do Not Disturb DNDMuting the Ringer Tone Dialing SWITCH-OVER Mute MicrophoneTraveling OUT Range Booster Handset OnlyConferencing Privacy ModeJoining a Conference Call Speed Dialing Find HandsetFrom a second handset Phonebook PhonebookIf you make a mistake while entering a name Store/Edit No. appears Storing Caller ID Messages in the Phonebook Storing a Redial RecordDeleting a Redial Record Viewing the PhonebookMaking Calls Using the Phonebook From Standby Mode Deleting ALL Phonebook Locations Base only From the handset Copying Phonebook LocationsTesting Stored Emergency Number From the baseCaller ID and Cidcw Caller ID on Call Waiting Incomplete DataCall Waiting Deluxe Features Viewing the Caller ID List Deleting Information from the Caller ID List Deleting ALL Caller ID NAME/NUMBERSFrom Talk mode From Standby ModeCalling a Party from the Caller ID List Four Multi-Handset Expandability Expanding Your PhoneRegister the Handset to the Base Using the Directlink Mode DirectLink callINTERCOM/CALL Transfer Feature IntercomFOUR-WAY Conferencing Making an Intercom From a handsetCall Transfer Feature Answering an IntercomAnswering a Call Transfer To answer a page from a handsetAccepting the call transfer To answer a page from the baseFeatures Integrated Answering DeviceRecord a Personal Outgoing Message Base Only Answering System SetupSelecting Your Greeting Base only Setting a PIN Code Setting the Ring TimeSetting the Record Time Setting the Message Alert On or OffSetting the Language of your Answering System Setting the Call ScreenTurning the message alert tone off by pressing any key Turning the message alert tone off from a remote locationUsing Your Answering System Turning the Answering System ON/OFFPlaying your messages New Message LEDRepeating a message Skipping a message Deleting a message Voice memo Recording a conversationRemote access away from home Remote OperationFunction Remote Key Function Remote access with the handsetAnsweringMachine operation appears on the base Integrated Answering Device Troubleshooting Symptom SuggestionKeep the handset away from microwave ovens Service and Repair CareMemo RadioShack Corporation