To set/clear the display of the base unit number on a handset
The factory setting is to display the number. This is useful if your handset is connected to more than one base unit.
Operating with additional base unit
To set your handset for automatic base selection
If you are moving around, and likely to lose contact with your base unit, your handset can be made to automatically switch to the first available base unit. If this is set and you are in
STO
7PQRS 6MNO
the area where the signals of two base units
•Press the STO button.
•Press the 3 button then the 6 button. The current setting is displayed.
•Press the 1 button to display the base unit
number.
or
•Press the 0 button if you do not want to display the base unit number.
•Press the STO button to confirm.
are overlapping, your handset will select the strongest signal.
The handset must be switched ON
STO |
|
| 0 |
INT |
| ||
|
| ||
|
|
|
|
•Press the STO button.
•Press the INT button. Display shows the numbers of the base stations at which the handset is registered.
•Press the 0 button to set automatic selection.
•Press the STO button to confirm. The handset will now select the base unit offering the strongest signal. Display will show the base unit selected (unless
48