Sanyo LNS-W10 instruction manual Basics, Clear message waiting, Standby mode, Receiving a call

INITIAL PROGRAMMING

Clear message waiting

1.Press the MENU/OK key.

2.Press or to select “CLEAR MSG WAIT”.

3.Press MENU/OK. The screen will show “CONFIRM?”

4. Press MENU/OK again to confirm or press C repeatedly to return to standby mode.

BASICS

When you first set your unit up, you may hear a beeping tone and see “OUT OF SERVICE” on the handset display area. This is normal, and means that the handset needs to synchronize with the base unit before you can use it. Place the handset on the charger for a few seconds until “READY” appears on the handset display.

Note: You can assign a name to the handset, When you do this your name will appear instead of “READY”. For instructions on how to assign a name to a handset, refer to the Handset name section on page 11 for more information.

Standby mode

If the handset is synchronized with the base unit and is not “ in use” or in

“programming mode ”, “READY” (or a name if entered) will appear on the LCD display.

Receiving a call

When an incoming call is received the handset will ring, “EXTERNAL CALL ” will show on the display, and the in-use LED on the base unit will flash*. If you are already on the line, a beep will announce you have a call waiting.

*If you subscribe to a Caller ID service from your phone company, Caller ID information shows on the display instead of “EXTERNAL CALL”.

1.Press TALK / any key (0-9) * or # to answer a call.

Note : If the handset is in the base cradle, remove it from the base before pressing the TALK key.

If “AUTO ANSWER” is enabled, you can accept an incoming call by simply lifting

the handset off the base. See the Auto answer section on page 13 for more information.

2.Press TALK again to hang up.

Note: If you place the handset back to the base cradle, the handset will automatically hang up.

14