Sanyo LNS-W10 instruction manual Cannot register handset, Cannot dial out, No Caller ID display

Page 30

If you just recharged the batteries, but keep getting a low battery warning, the batteries may need to be replaced. Rechargeable batteries gradually lose their ability to store a charge the older they get. Replace the battery with a new one.

MULTI-HANDSET USE

Cannot register handset

∙ Sometimes it helps to unplug and then reconnect your base unit to its AC power source before you start the registration procedure.

∙ You may have already registered 4 handsets to the base unit.

∙ If you are replacing a faulty handset, make sure you have fully removed the

faulty one before registering the new one. Refer to the Registering a handset section on page 21 for more information.

TROUBLESHOOTING

∙ If you are still experiencing problems, you may need to reset all the registrations then start over.

Cannot dial out

Only one outside call and one intercom call can take place at the same time. Make

sure no one else is already using the phone; if so, you will see the EXT IN USE symbol on the handset display area.

All handsets show “OUT OF SERVICE” and telephone will not work

Reset your telephone, and then try the registration process again. If you are still experiencing problems, reset and then re-register all your handsets one-by-one.

CALLER ID

No Caller ID display

∙	You must subscribe for caller ID services through your telephone network
	provider for the caller ID to display on this telephone. Please check with
	your provider.
∙	If the caller’s number does not exactly match what you have entered in
	your phone book, including the STD code and any prefixes, the phone book
	cannot match the name to the caller ID. Check the phone book to make
∙	sure the full number is stored there in the correct sequence.
∙	Is battery fully charged? Try recharging or replacing the battery	.
∙	Make sure that the base is connected to a non-switched AC outlet.
	Disconnect the base from the plug and plug it in again.

30

Image 30

Contents GHz Sanyo Canada IncTable of Contents Causes of Poor Reception ...………………..……………………30 Introduction Main Features GHz TechnologyOther features Compander Plus Noise ReductionChecking package contents Getting StartedModular jack Connecting the base unit Choosing a location for the base unit and handset cradleConnecting the handset cradle Batteries Charging the handset batteries Names and Controls HandsetBase unit Language Dial modeInitial Programming Handset nameKey tone Flash timeKey lock Handset ring toneAuto answer on / off Handset ring volume levelEarpiece volume level Tip To return to standby mode, pressClear message waiting Standby modeBasics Receiving a callReturning missed calls Correcting a dialing errorMaking a call Talk keyMute key C Low battery warningVoice mail indicator Handset locator page keyCaller ID list Caller ID FeaturesCaller ID with Call Waiting Reviewing Caller ID listStoring a name / number in the directory DirectoryDeleting entries from the Caller ID list Deleting the displayed entryKey Key of times pressed TipChanging a stored entry Making calls from the directoryDeleting an entry Storing caller ID entries in the directoryIdentifying a handset on the network MULTI-HANDSET ConfigurationRegistering a handset Intercom internal callIntercom ring tone Call togglingTransferring call between handsets Way conference callCall Waiting INT forCall back Changing the Handset BatteryBattery replacement and handling Display. Another party can answer the call by pressingHeadset Jack and Belt Clip Replacing the batteryRecycling NICKEL-METAL Hydride Batteries Headset connection headset not includedPower Failure LCD Screen MessagesLight Signals CHARGE/IN USE LED on the baseNo dial tone Sound SignalsTroubleshooting Dial tone is OK, but cannot dial outKeys do not work Handset does not ringCall was disconnected Phone beepsCannot register handset Cannot dial outNo Caller ID display Maintenance Maximize Battery PerformanceCaller ID error message Refresh battery Charge the battery for a full 15 continuous hoursKeep the contacts clean Do not replace the handset in the base after each callTechnical Information REN NumberSanyo Comfort Warranty Warranty ApplicationWhat is not Covered SOS Help Line Nationwide Customer Support