Sanyo LNS-W10 instruction manual Power Failure, LCD Screen Messages

Page 26

POWER FAILURE

When power is off, you will not be able to make or receive calls with the telephone.

After a power outage, it may take a few seconds for the handset to reconnect to the base unit.

LCD SCREEN MESSAGES

The following indicators show the status of a message or of the phone.

BASE PAGING	Someone has pressed PAGE on the base unit

BUSY	The dialed number or handset is busy

CALL ALL	An intercom call has been placed to all
	registered handsets
CALL BACK	A forwarded call was not answered

CHARGING	Battery is charging

CONFERENCE CALL	2 handsets are on a conference call

ENDED	The call has ended. The elapsed time for the
	call also shows.
EXT IN USE	Another handset is already on an external call

EXTERNAL CALL	A call was received with no Caller ID
	information provided
FAIL	Registration did not occur

H	A call has been placed on hold

INTERNAL CALL	An intercom call has been placed from the
HANDSET # / HANDSET NAME	displayed handset
MIC MUTE	The handset is in mute mode

PRIVATE # / NAME / CALLER	Some or all of the Caller ID information was
	blocked
READY	Phone is charged and ready to make or receive
	calls
TALK	Phone is in Talk mode (ready to place a call or
	on a call). If on a call, the duration of the call
	also shows

26

Image 26

Contents GHz Sanyo Canada IncTable of Contents Causes of Poor Reception ...………………..……………………30 Introduction Main Features GHz TechnologyOther features Compander Plus Noise ReductionModular jack Checking package contentsGetting Started Connecting the base unit Choosing a location for the base unit and handset cradleConnecting the handset cradle Batteries Charging the handset batteries Names and Controls HandsetBase unit Language Dial modeInitial Programming Handset nameKey tone Flash timeKey lock Handset ring toneAuto answer on / off Handset ring volume levelEarpiece volume level Tip To return to standby mode, pressClear message waiting Standby modeBasics Receiving a callReturning missed calls Correcting a dialing errorMaking a call Talk keyMute key C Low battery warningVoice mail indicator Handset locator page keyCaller ID list Caller ID FeaturesCaller ID with Call Waiting Reviewing Caller ID listStoring a name / number in the directory DirectoryDeleting entries from the Caller ID list Deleting the displayed entryKey Key of times pressed TipChanging a stored entry Making calls from the directoryDeleting an entry Storing caller ID entries in the directoryIdentifying a handset on the network MULTI-HANDSET ConfigurationRegistering a handset Intercom internal callIntercom ring tone Call togglingTransferring call between handsets Way conference callCall Waiting INT forCall back Changing the Handset BatteryBattery replacement and handling Display. Another party can answer the call by pressingHeadset Jack and Belt Clip Replacing the batteryRecycling NICKEL-METAL Hydride Batteries Headset connection headset not includedPower Failure LCD Screen MessagesLight Signals CHARGE/IN USE LED on the baseNo dial tone Sound SignalsTroubleshooting Dial tone is OK, but cannot dial outKeys do not work Handset does not ringCall was disconnected Phone beepsNo Caller ID display Cannot register handsetCannot dial out Caller ID error message MaintenanceMaximize Battery Performance Refresh battery Charge the battery for a full 15 continuous hoursKeep the contacts clean Do not replace the handset in the base after each callTechnical Information REN NumberSanyo Comfort Warranty Warranty ApplicationWhat is not Covered SOS Help Line Nationwide Customer Support