Talking | Lit steadily | (red) |
Charging | Lit steadily | (green) |
Incoming call | Flashes in same pattern as telephone ring (red) | |
Voice mail | Flashes every 2 seconds (red) | |
No telephone line | Flashes every 1 seconds (red) | |
SOUND SIGNALS
A long warbling tone | Signals an incoming call |
|
Single tone | A key is pressed |
|
Two short beeps | Call waiting / MIC mute |
|
One long beep | Confirmation tone / Page signal / Call |
|
| back |
|
Three short beeps | Error tone / Out of range |
|
Two short beeps every 15 seconds | Low battery warning |
|
|
|
|
TROUBLESHOOTING |
|
|
TELEPHONE |
|
|
No dial tone
Check installation:
∙ Is the base unit plugged into the telephone line and AC power source? If the telephone line is not properly connected to the base unit NO LINE will appear on the handset display.
∙ Is the AC power source turned on at the socket? ∙ Are the batteries properly installed in the handset?
Dial tone is OK, but cannot dial out
∙ Try moving the handset closer to the base unit.
∙ If this doesn’t work, try a different position for the base unit. Typically, the higher you place the base unit, the better the reception.
∙ The battery charge level may be low. Check the LCD display for the low
28