Getting started
Headset charger installation
Install the headset charger as shown below.
Plug the small end of the headset charger power adapter into the power jack of the headset charger.
Plug the large end of the
headset charger power adapter into an electrical outlet not controlled by a wall switch.
Headset charger
Power on the headset
Power on the headset before use. Place the headset in the headset charger or press and hold for two seconds. The light flashes three times in blue and you hear three beeps when the headset is being powered on.
If the headset will not be used for a long time, press and hold for two seconds to power off the headset. The light flashes three times in red and you hear three beeps when the headset is being powered off.
Headset charging
After installing the headset charger, charge the headset as shown below. The headset is fully charged after three hours of continuous charging. If the light does not turn on while charging, you need to charge the headset without interruption for at least 15 minutes to give the headset enough charge to use for a short time. For best performance, keep the headset in the headset charger when not in use. See the table on page 104 for battery operating times.
1.Place the tip of the headset in the small cradle on
the headset charger.
2. The magnet holds the top of the
headset in place. The light turns on when charging.
The headset battery is not replaceable.