Answering system operation
NOTE: If the clock was not set when a message was recorded, the system will announce "Time and day not set" before the message is played back.
Day & time announcement
To check day & time
You can press CLOCK when the system is idle to hear the current day and time.
If you subscribe to caller ID service from your local telephone company, the time will automatically be set with every incoming call. You must set the year so that the day of the week can be calculated from the caller ID information.
If you do not hear the correct time, day, and year, follow the steps below.
To set day & time
Before playing each message, the answering system announces the day and time the message was received.
Follow the steps below to set the year, time and day, so the day and time are correct. Each time you press 
SKIP or 
REPEAT, the year, hour, minute or day increases or decreases by one. Press and hold 
SKIP or 
REPEAT to increase or decrease the minutes or year by increments of ten. When you hear the correct setting, press CLOCK to move to the next setting.
1.Press CLOCK, the system will announce the current clock setting, and then announce “To set the clock, press CLOCK.”
2.Press CLOCK, The system will announce the current year setting, and then announce “To change the year, press SKIP or REPEAT, to change the hour, press CLOCK.”
3.Press CLOCK, The system will announce the current hour setting, and then announce “To change the hour, press SKIP or REPEAT, to change the minute, press CLOCK.”
4.Press CLOCK, The system will announce the current minute setting, and then announce “To change the minute, press SKIP or REPEAT, to change the day, press CLOCK.”
5.Press CLOCK, The system will announce the current day setting, and then announce “To change the day, press SKIP or REPEAT, press CLOCK when you are done.”
6.Press CLOCK. The system announces the current clock setting.
38