Uniden 7000A manual Preparation, Setting the DAY and Time

Page 19

PREPARATION

SETTING THE DAY AND TIME

The DTAM records the day and time of the call with each phone message. Follow these steps to set the current day and time.

NOTE: • Adjust Volume Slider on the right side of the DTAM to the desired listening level.

•If you do not complete each step within 8 seconds, the DTAM sounds four beeps, you must then start again from Step 1.

•To avoid having to reset the time if AC power is lost, we recommend you install a backup battery before you set the day and time.

1.Press and hold down time set button until the DTAM announces the day of the week.

Release the time set button.

2.Press or until

the DTAM announces the desired day of the week.

3.Press time set The DTAM announces the preset hour.

4.	Press	or		until the DTAM announces the desired
	hour.	time set The DTAM announces the preset minute.
5.	Press	time set The DTAM announces the preset minute.
6.	Hold down		or	until the DTAM announces the
	desired minute.
7.	Press	time set	to confirm the settings,		appears.
	The DTAM announces the day and time then beeps. disappears.
To check the current day/time at any time, press					time set

PREPARATION

19

Image 19

Contents 7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Answer FunctionsOutgoing Message Message LightFunctions Selecting a Location InstallationUse only the Uniden AC Adaptor supplied with this InstallationConnecting Power Backup BatteryPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeTo record the OGM 1 message PreparationRecording the Outgoing Messages Recording the Outgoing MessagesDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage To Announce Only Setting the Dtam to Answer CallsBasic Operation To Turn The Dtam OnAnswer the call, pick up the phone and press on the Dtam Basic OperationRecording Incoming Messages Screening CallsPlaying Messages Adjusting the VolumeDown for 2 seconds Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughPress Dtam beeps Changing the CBT CodeReappears. For This page is left intentionally blank Remote Answer-on Remote OperationRemote Operation Call your telephoneThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingIf all of the above suggestions do not resolve TroubleshootingYour problem, use a straightened paper Clip to press Reset on the backUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead