Uniden 7000A manual Warranty, Setting the Number of Rings

Page 23

PREPARATION

SETTING THE NUMBER OF RINGS

The ring select switch on the back of the DTAM controls how long the DTAM waits before it answers a call. Slide the switch to the desired position.

2The DTAM answers after two rings.

4The DTAM answers after four rings.

7The DTAM answers after seven rings.

T.S. (Toll Saver) - If there are new messages, the DTAM answers after two rings. Otherwise, the DTAM answers after four rings. This helps you avoid unnecessary toll charges when calling by long distance to check your messages. If you hear more than two rings, you know you can hang up because the DTAM has no new messages.

NOTE:

• When the memory is full the DTAM answers the call and

 

 

 

 

plays OGM2 (the announce only message).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WARRANTY

PREPARATION

23

Image 23
Contents 7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Answer FunctionsOutgoing Message Message LightFunctions Selecting a Location InstallationUse only the Uniden AC Adaptor supplied with this InstallationConnecting Power Backup BatteryPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeTo record the OGM 1 message PreparationRecording the Outgoing Messages Recording the Outgoing MessagesDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage To Announce Only Setting the Dtam to Answer CallsBasic Operation To Turn The Dtam OnAnswer the call, pick up the phone and press on the Dtam Basic OperationRecording Incoming Messages Screening CallsDown for 2 seconds Adjusting the VolumePlaying Messages Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughReappears. For Changing the CBT CodePress Dtam beeps This page is left intentionally blank Remote Answer-on Remote OperationRemote Operation Call your telephoneThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingIf all of the above suggestions do not resolve TroubleshootingYour problem, use a straightened paper Clip to press Reset on the backUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead