Uniden 7000A manual To record an OGM 2 message Hold down OGM 2 until

Page 21

PREPARATION

NOTE:				Do not tell the callers that you are not home. Instead, say that
				you cannot come to the phone right now.

2.Speak in a normal voice about 20cm (8 inches) away from the microphone (located on the front of the DTAM). If you record the OGM 1 message, ask for the caller’s name, phone number and message.

3.When you finish recording,

press . The DTAM automatically plays back the outgoing message.

To record an OGM 2 message,

hold down OGM 2 until the

DTAM beeps and (Announcement 2) appears. Repeat steps 2 and 3.

NOTE:	• If no outgoing OGM1 is recorded when you press	OGM 1 , the

DTAM announces "You have no announcement one" and sounds four beeps.

•If no outgoing OGM2 is recorded when you press OGM 2 , the DTAM announces "You have no announcement two" and sounds four beeps.

PREPARATION

21

Image 21

Contents 7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Outgoing Message FunctionsMessage Light AnswerFunctions Selecting a Location InstallationConnecting Power InstallationBackup Battery Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeRecording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 messageDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage Basic Operation Setting the Dtam to Answer CallsTo Turn The Dtam On To Announce OnlyRecording Incoming Messages Basic OperationScreening Calls Answer the call, pick up the phone and press on the DtamAdjusting the Volume Playing MessagesDown for 2 seconds Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughChanging the CBT Code Press Dtam beepsReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-onThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingYour problem, use a straightened paper TroubleshootingClip to press Reset on the back If all of the above suggestions do not resolveUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead