Uniden 7000A manual Remote Operation, Call your telephone, Remote Answer-on

Page 33

REMOTE OPERATION

REMOTE OPERATION

You can operate the DTAM from any remote location using a touch-tone phone, or from a rotary phone using a pocket tone- dialler.

Call your telephone

When you hear the OGM, enter your security code. After a long beep, enter your remote command code(s).

If you do not hear an OGM, the unit is either in Answer-off mode or is not setup properly.

Remote Answer-on

•Call your telephone (After 15 rings you will hear "Answer Off")

•Enter your remote security code within 8 seconds. (The DTAM beeps to confirm valid code)

•Enter 0 1 for OGM1 or 0 2 for OGM2 (Announce only)

•The DTAM announces "Answer On’, Then plays your selected OGM.

REMOTE OPERATION

NOTE: • An outgoing message must be recorded before you can remotely set the DTAM to answer calls.

•If you do not enter each digit of the security code within 8 seconds, the DTAM hangs up. If the DTAM is set to answer-on, it answers according to the number of rings you set. The DTAM plays OGM1.

33

Image 33

Contents 7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Outgoing Message FunctionsMessage Light AnswerFunctions Selecting a Location InstallationConnecting Power InstallationBackup Battery Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeRecording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 messageDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage Basic Operation Setting the Dtam to Answer CallsTo Turn The Dtam On To Announce OnlyRecording Incoming Messages Basic OperationScreening Calls Answer the call, pick up the phone and press on the DtamAdjusting the Volume Playing MessagesDown for 2 seconds Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughChanging the CBT Code Press Dtam beepsReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-onThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingYour problem, use a straightened paper TroubleshootingClip to press Reset on the back If all of the above suggestions do not resolveUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead