Uniden 7000A manual Troubleshooting, If all of the above suggestions do not resolve, Machine

Page 38

TROUBLESHOOTING

TROUBLESHOOTING	PROBLEM	SUGGESTION

	Clock loses time.	• The power to the base unit has been
	Cannot access remote call-in features from	• Make sure you’re using the correct PIN
	another touch-tone phone.	number.
		• Make sure that the touch-tone phone
		you’re using can transmit the tone for at
		least two seconds. If it cannot, you may
		have to change to another phone.

		interrupted. Reset the clock as detailed
		on page (19) of this owners manual.

	Message counter LED flashes	• Follow the instructions on page (16).
	(Battery low or not fitted)	Be sure to leave the AC Adaptor connected
		so you do not loose the stored information.

	Answering system switches on after 9 rings,	• The unit is waiting for your PIN number so
	beeps once, then disconnects after 8 seconds	you can clear message from a remote
		location. Refer to page 33 for more details.

	RESETTING THE DTAM
	If all of the above suggestions do not resolve
	your problem, use a straightened paper
	clip to press RESET on the back of
	the DTAM to reset the answering
	machine.

NOTE:	Resetting the DTAM erases your outgoing messages and all stored

	information.

Disconnect the telephone line cord before operating the

RESET switch.

38

Image 38

Contents 7000A Page Contents Contents Safety Information Read this Before InstallationSafety Information Safety InformationIntroduction Page 7000A Dtam AC AdaptorPage Features Your DTAM’S Features IncludeFeatures Message Light FunctionsOutgoing Message AnswerFunctions Installation Selecting a LocationBackup Battery InstallationConnecting Power Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Setting the DAY and Time PreparationRecording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 messageTo record an OGM 2 message Hold down OGM 2 until Dtam beeps and Announcement 2 appears. Repeat steps 2Preparation Warranty Setting the Number of RingsPage To Turn The Dtam On Setting the Dtam to Answer CallsBasic Operation To Announce OnlyScreening Calls Basic OperationRecording Incoming Messages Answer the call, pick up the phone and press on the DtamDown for 2 seconds Adjusting the VolumePlaying Messages Pause Message Playback Fast Playback Deleting MessagesUsing Call Breakthrough Recording a MemoReappears. For Changing the CBT CodePress Dtam beeps This page is left intentionally blank Call your telephone Remote OperationRemote Operation Remote Answer-onRemote Operation ThenUsing Remote Commands PressRemote Operation Troubleshooting Problem SuggestionClip to press Reset on the back TroubleshootingYour problem, use a straightened paper If all of the above suggestions do not resolveCare and Maintenance Unplug the unit before cleaning itPage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead