Uniden 7000A manual Features

Page 12

FEATURES

FEATURES

Call Screening

Lets you listen as a caller leaves a message so you can decide whether or not to answer the call.

Call Break-Through (CBT) with Programmable Code Alerts you to an important call when the caller enters a preset code during the outgoing message.

Memory Backup

Protects messages stored in memory in case of a power failure. Requires a 9 volt battery (not supplied).

Adjustable Ring Number

Lets you set the DTAM to answer the phone after two rings, four rings or seven rings.

Toll Saver

Lets you avoid unnecessary long distance charges when you call by long distance to check your messages.

Room Monitor

Lets you listen from a remote phone to the room where you installed the DTAM.

answer Lets you turn the DTAM on or off.

Call/Message Counter

Shows the number of messages the DTAM has recorded.

delete Lets you quickly delete messages individually or all at once.

Remote Access

Lets you turn the DTAM on or off and listen to messages when you are away from your home or office.

Memo Recording

Lets you leave messages for yourself or others in your home or office.

12

Image 12

Contents 7000A Page Contents Contents Safety Information Read this Before InstallationSafety Information Safety InformationIntroduction Page 7000A Dtam AC AdaptorPage Features Your DTAM’S Features IncludeFeatures Functions Outgoing MessageMessage Light AnswerFunctions Installation Selecting a LocationInstallation Connecting PowerBackup Battery Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Setting the DAY and Time PreparationPreparation Recording the Outgoing MessagesRecording the Outgoing Messages To record the OGM 1 messageTo record an OGM 2 message Hold down OGM 2 until Dtam beeps and Announcement 2 appears. Repeat steps 2Preparation Warranty Setting the Number of RingsPage Setting the Dtam to Answer Calls Basic OperationTo Turn The Dtam On To Announce OnlyBasic Operation Recording Incoming MessagesScreening Calls Answer the call, pick up the phone and press on the DtamAdjusting the Volume Playing MessagesDown for 2 seconds Pause Message Playback Fast Playback Deleting MessagesUsing Call Breakthrough Recording a MemoChanging the CBT Code Press Dtam beepsReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-onRemote Operation ThenUsing Remote Commands PressRemote Operation Troubleshooting Problem SuggestionTroubleshooting Your problem, use a straightened paperClip to press Reset on the back If all of the above suggestions do not resolveCare and Maintenance Unplug the unit before cleaning itPage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead