Uniden 7000A manual Changing the CBT Code, Press Dtam beeps, Reappears. For

Page 31

BASIC OPERATION

When a caller enters the CBT code, the DTAM alerts you with loud beeps for 35 seconds. Then the DTAM sounds two beeps every two seconds for 30 seconds, and one short beep every second for the last 5 seconds. To answer the call, pick up the handset. If you do not answer, the caller can leave a message after the outgoing message plays and a long beep sounds.

CHANGING THE CBT CODE

The CBT code is preset to 648, but you can change it by following these steps:

1. Hold down code set until the DTAM beeps once appears.

BASIC OPERATION

NOTE:				Be sure to set each digit within 8 seconds. Otherwise, you must start
				over from Step 1.







2. Press				The DTAM beeps and					appears followed by the
	digits of the preset CBT code in sequence, then the first digit
	reappears. For				example, when the security code is 648, the
	display shows					,	,	, then	reappears.

3.Repeatedly press or to set the first digit, then

press . The second digit appears.

4.Press or to set the second digit, then press The third digit appears.

5.Press or to set the third digit, then press The DTAM sounds a long beep and announces the CBT code.

31

Image 31

Contents

7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Answer FunctionsOutgoing Message Message LightFunctions Selecting a Location InstallationUse only the Uniden AC Adaptor supplied with this InstallationConnecting Power Backup BatteryPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeTo record the OGM 1 message PreparationRecording the Outgoing Messages Recording the Outgoing MessagesDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage To Announce Only Setting the Dtam to Answer CallsBasic Operation To Turn The Dtam OnAnswer the call, pick up the phone and press on the Dtam Basic OperationRecording Incoming Messages Screening CallsPlaying Messages Adjusting the VolumeDown for 2 seconds Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughPress Dtam beeps Changing the CBT CodeReappears. For This page is left intentionally blank Remote Answer-on Remote OperationRemote Operation Call your telephoneThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingIf all of the above suggestions do not resolve TroubleshootingYour problem, use a straightened paper Clip to press Reset on the backUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead