Uniden 7000A Installation, Connecting Power, Use only the Uniden AC Adaptor supplied with this

Page 16

INSTALLATION

INSTALLATION

CONNECTING POWER

Use only the Uniden AC Adaptor supplied with this

Uniden 7000A Digital Telephone Answering Machine.

1.Plug the AC Adaptor into the power socket at the rear of the DTAM labelled “9 V AC 400mA”.

2.Then plug the other end into your mains socket.

When you first connect power, the DTAM beeps once and announces "Please wait". The message counter counts up from 0

to 18. Then the DTAM beeps. , , , and alternatively appear to indicate that no outgoing messages are recorded.

NOTE:	The display will flash	if there is no back up battery fitted or

if the back up battery is low.

BACKUP BATTERY

If the power fails or you unplug the DTAM, a 9V backup battery (not supplied) would save the messages and the settings for the day, time and security code. We recommend you use an alkaline battery.

16

Image 16

Contents 7000A Page Contents Contents Safety Information Read this Before InstallationSafety Information Safety InformationIntroduction Page 7000A Dtam AC AdaptorPage Features Your DTAM’S Features IncludeFeatures Functions Outgoing MessageMessage Light AnswerFunctions Installation Selecting a LocationInstallation Connecting PowerBackup Battery Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Setting the DAY and Time PreparationPreparation Recording the Outgoing MessagesRecording the Outgoing Messages To record the OGM 1 messageTo record an OGM 2 message Hold down OGM 2 until Dtam beeps and Announcement 2 appears. Repeat steps 2Preparation Warranty Setting the Number of RingsPage Setting the Dtam to Answer Calls Basic OperationTo Turn The Dtam On To Announce OnlyBasic Operation Recording Incoming MessagesScreening Calls Answer the call, pick up the phone and press on the DtamPlaying Messages Adjusting the VolumeDown for 2 seconds Pause Message Playback Fast Playback Deleting MessagesUsing Call Breakthrough Recording a MemoPress Dtam beeps Changing the CBT CodeReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-onRemote Operation ThenUsing Remote Commands PressRemote Operation Troubleshooting Problem SuggestionTroubleshooting Your problem, use a straightened paperClip to press Reset on the back If all of the above suggestions do not resolveCare and Maintenance Unplug the unit before cleaning itPage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead