Uniden 7000A manual Adjusting the Volume, Playing Messages, Down for 2 seconds

Page 27

BASIC OPERATION

ADJUSTING THE VOLUME

Adjust volume slider, on the right side of the DTAM to the desired listening level.

PLAYING MESSAGES

The display shows the total number of messages. If there are new messages, the message light also flashes until all new messages have been played.

To play all the messages (old and new), press . The DTAM announces the number of messages recorded, each

message number and the day and time the message was recorded and then plays the message.

PLAYING NEW MESSAGES ONLY To play only new messages, hold

down for 2 seconds.

(If there are no new messages stored, the DTAM says "You have no new messages").

Adjust the volume to your desired listening level. After all messages have played, the DTAM says, "End of message(s)" and saves all the messages.

BASIC OPERATION

27

Image 27

Contents 7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Answer FunctionsOutgoing Message Message LightFunctions Selecting a Location InstallationUse only the Uniden AC Adaptor supplied with this InstallationConnecting Power Backup BatteryPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeTo record the OGM 1 message PreparationRecording the Outgoing Messages Recording the Outgoing MessagesDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage To Announce Only Setting the Dtam to Answer CallsBasic Operation To Turn The Dtam OnAnswer the call, pick up the phone and press on the Dtam Basic OperationRecording Incoming Messages Screening CallsAdjusting the Volume Playing MessagesDown for 2 seconds Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughChanging the CBT Code Press Dtam beepsReappears. For This page is left intentionally blank Remote Answer-on Remote OperationRemote Operation Call your telephoneThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingIf all of the above suggestions do not resolve TroubleshootingYour problem, use a straightened paper Clip to press Reset on the backUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead