Uniden 7000A manual Troubleshooting, Problem Suggestion

Page 37

TROUBLESHOOTING

If your 7000A DTAM unit is not performing to your expectations, please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service for assistance.

New Zealand: 0800 4 UNIDEN	Australia: 1800 632 789
4 864336

PROBLEM	SUGGESTION
Answering system does not work	• Make sure the telephone line cord
	is plugged in.
	• Make sure that the AC Adaptor
	is plugged in.
	• Make sure the DTAM is turned on.
	• There has been a power failure.
	Disconnect the telephone line cord,
	press the reset button and re-connect
	the telephone line cord.

Answering System does not answers	• The memory may be full. Delete some
after 3 rings.	or all of the saved messages.
after 3 rings.	or all of the saved messages.		TROUBLESHOOTING

Messages are incomplete.	• The incoming messages may be too long.
Messages are incomplete.	• The incoming messages may be too long.
	• The memory may be full. Delete some
	or all of the saved messages.

No sound on the base unit speaker during	• Adjust the volume control on the side of
call monitoring or message playback.	the DTAM. Refer page 27

Cannot record outgoing message (OGM)	• The memory may be full. Delete some or
	all of the saved messages.

	Continued over....

37

Image 37

Contents 7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Outgoing Message FunctionsMessage Light AnswerFunctions Selecting a Location InstallationConnecting Power InstallationBackup Battery Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeRecording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 messageDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage Basic Operation Setting the Dtam to Answer CallsTo Turn The Dtam On To Announce OnlyRecording Incoming Messages Basic OperationScreening Calls Answer the call, pick up the phone and press on the DtamPlaying Messages Adjusting the VolumeDown for 2 seconds Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughPress Dtam beeps Changing the CBT CodeReappears. For This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-onThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingYour problem, use a straightened paper TroubleshootingClip to press Reset on the back If all of the above suggestions do not resolveUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead