Uniden 7000A manual Remote Operation, Then

Page 34

REMOTE OPERATION

REMOTE OPERATION

CHANGING THE REMOTE OPERATION SECURITY CODE The remote operation security code is preset to 798, but you can change it by following these steps.

1.Hold down code set until the DTAM beeps once. appears.

2.Pressagain. (security code) and the digits of the current code appear in sequence, then the first digit reappears. For example, when the security code is 798, the display shows

(security code)

,

,

, then

reappears.

3.Repeatedly press or to set the first digit, then

press . The second digit appears.

4.Press or to set the second digit, then press The third digit appears.

5.Press or to set the third digit, then press The DTAM sounds a long beep and announces the security code.

NOTE:				Be sure to set each digit within 8 seconds. Otherwise, you must start
				over from Step 1.

34

Image 34

Contents 7000A Page Contents Contents Safety Information Read this Before InstallationSafety Information Safety InformationIntroduction Page 7000A Dtam AC AdaptorPage Features Your DTAM’S Features IncludeFeatures Message Light FunctionsOutgoing Message AnswerFunctions Installation Selecting a LocationBackup Battery InstallationConnecting Power Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Setting the DAY and Time PreparationRecording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 messageTo record an OGM 2 message Hold down OGM 2 until Dtam beeps and Announcement 2 appears. Repeat steps 2Preparation Warranty Setting the Number of RingsPage To Turn The Dtam On Setting the Dtam to Answer CallsBasic Operation To Announce OnlyScreening Calls Basic OperationRecording Incoming Messages Answer the call, pick up the phone and press on the DtamPlaying Messages Adjusting the VolumeDown for 2 seconds Pause Message Playback Fast Playback Deleting MessagesUsing Call Breakthrough Recording a MemoPress Dtam beeps Changing the CBT CodeReappears. For This page is left intentionally blank Call your telephone Remote OperationRemote Operation Remote Answer-onRemote Operation ThenUsing Remote Commands PressRemote Operation Troubleshooting Problem SuggestionClip to press Reset on the back TroubleshootingYour problem, use a straightened paper If all of the above suggestions do not resolveCare and Maintenance Unplug the unit before cleaning itPage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead