Uniden 7000A manual Fast Playback, Deleting Messages

Page 29

BASIC OPERATION

FAST PLAYBACK

During message playback, press and keep holding , the message playback speed increases. This lets you quickly scan a message or move to any place within a message. To resume to

normal playback, release.

To stop playback at any time, press the .

The DTAM beeps and resets to answer calls.

DELETING MESSAGES

To delete a specific message, press delete once while the message is playing. The DTAM beeps once and deletes the current message, then plays the next.

To delete all messages, hold down delete when playback has

finished. appears, the DTAM announces "Erase message(s)", then sounds a long beep.

NOTE:				The DTAM does not delete messages that have not been played to the
				end. If you have messages that have not been played, the DTAM






				sounds four beeps.
				sounds four beeps.

BASIC OPERATION

29

Image 29

Contents 7000A Page Contents Contents Read this Before Installation Safety InformationSafety Information Safety InformationIntroduction Page AC Adaptor 7000A DtamPage Your DTAM’S Features Include FeaturesFeatures Outgoing Message FunctionsMessage Light AnswerFunctions Selecting a Location InstallationConnecting Power InstallationBackup Battery Use only the Uniden AC Adaptor supplied with thisPush down the latch to release the battery compartment cover Page Preparation Setting the DAY and TimeRecording the Outgoing Messages PreparationRecording the Outgoing Messages To record the OGM 1 messageDtam beeps and Announcement 2 appears. Repeat steps 2 To record an OGM 2 message Hold down OGM 2 untilPreparation Setting the Number of Rings WarrantyPage Basic Operation Setting the Dtam to Answer CallsTo Turn The Dtam On To Announce OnlyRecording Incoming Messages Basic OperationScreening Calls Answer the call, pick up the phone and press on the DtamDown for 2 seconds Adjusting the VolumePlaying Messages Pause Message Playback Deleting Messages Fast PlaybackRecording a Memo Using Call BreakthroughReappears. For Changing the CBT CodePress Dtam beeps This page is left intentionally blank Remote Operation Remote OperationCall your telephone Remote Answer-onThen Remote OperationPress Using Remote CommandsRemote Operation Problem Suggestion TroubleshootingYour problem, use a straightened paper TroubleshootingClip to press Reset on the back If all of the above suggestions do not resolveUnplug the unit before cleaning it Care and MaintenancePage Procedure for Obtaining Performance of Warranty Clear Signal of What’s Ahead