Nortel Networks 4070 quick start New in this release, Features, Other changes

Page 17

17

New in this release

The following sections detail what’s new in Nortel Secure Network Access Installation — Quick Start Switch 4070 (NN47230-303) for Release 2.0.

"Features" (page 17)

"Other changes" (page 17)

Features

This is the first standard release of the document.

Other changes

None.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008

Copyright © 2008, Nortel Networks

Image 17
Contents Installation Quick Start Switch Legal Notice Contents Installation International Regulatory Statements of Conformity Regulatory Information and Safety PrecautionsCE marking statement Europe only Ices statement Canada onlyEN 55022 statement EN 55024 statementVcci statement Japan/Nippon only National Safety Statements of Compliance EN 60950 statementMIC notice Republic of Korea only NOM statement Mexico onlyInformación NOM unicamente para México Denan statement Japan/Nippon onlyWeee Directive Compliance Statement National Environmental Statements of ComplianceRegulatory Information and Safety Precautions Trademarks TrademarksRegulatory Information and Safety Precautions Nortel Networks software license agreement Software licenseGeneral Nortel Networks software license agreement Software license Other changes FeaturesNew in this release New in this release Navigation IntroductionPrerequisites Introduction Safety precautions Installation preparationSafety precautions navigation Personal safety before installing the deviceCable and connector safety Procedure steps Installation checklistInstallation preparation Unpacking the device InstallationPrerequisites for installing an Nsna into a rack Installing an Nsna device into a rackInstalling an Nsna device into a rack Installation Installing an Nsna device into a rack Connecting serial cables Connecting network cablesCabling the device Cabling the device navigationSerial connection parameters Parameter Value Installation Prerequisites ConfigurationCreating a new cluster Specify the network connectivity port Enter a default gateway address Joining an Snas to an existing cluster Procedure steps Enabling the browser-based interface To enable the BBI, perform the following procedure Endpoints Applying the Nortel Snas licenseThrough BBI Enter the command /cfg/sys/host hostnumber/license Page Installation Quick Start Switch